Car Subwoofers Phantom DVM-110  all car subwoofers →

Protects against surround and cone damage. Sized to fit Gen-3 P2 & P3 woofers. Stamped mesh grille insert.

Protects against surround and cone damage. Sized to fit Gen-3 P2 & P3 woofers. Stamped mesh grille insert.

Protects against surround and cone damage. Sized to fit Gen-3 P2 & P3 woofers. Stamped mesh grille insert.

Boss R935, 5-Channel Mosfet Power Amplifier, Riot Series + Subwoofer Remote Control, 4 x 80 Watts RMS + 1 x 150 watts @ 4 ohms stereo, 4x 150 Watt RMS + 1 x 300 Watts @ 2 ohm stereo

2) NEW ROCKFORD FOSGATE **R2D4-12** 12" 1000W 4-Ohm DVC Prime R2 Car Audio Subwoofer Power Handling (Max): 500 Watts per sub (1000 Watts per pair) Power Handling (RMS): 250 Watts per sub (500 Watts per pair) Features: 12-gauge compression terminals

20cm (8) Active Underseat Subwoofer. Power: 150/300 Watts RMS/MAX Class-D. low pass 50-120 Hz. bass boost 0-12db @ 45 Hz. high/low level input. auto-on (audio/DC offset). phase shift 0-180°. includes PLC bass remote control. dimensions: 36.5 x 23.8 x 8.5 cm

1000 Watts MAX / 500 watts RMS 42 Hz frequency response and 88dB sensitivity Aluminium Voice Coil Subwoofer with treated paper membrane and rubber base

Inserts slugly into Gen-2 P3S trim rings. Protects against surround and cone damage. Sized to fit Gen-2 P3S woofers

Bundle includes: 2 Rockford Fosgate P2D4-12 12” Subwoofer - DVC (dual 4-Ohm), 400 Watts Rms, 800 Watts Peak Dual linear spider with embedded 16 AWG tinsel leads Custom 10-AWG nickel plated push terminals Features C.L.E.A.N. Set-up Optional remote Punch Level Control (PLC2) ready (w/ input clip indicator)

Boss NEO12, 12" (30cm), Ripper Series, 300W RMS, 600W MAX, Impedancy: 4 ohms

BUILT-IN AMPLIFIER: A built-in 1200 Max watt amplifier powers the subwoofer PULSE WIDTH MODULATED: This design controls the output voltage and current precisely by not only removing the output current sensing loss, but also eliminating all secondary feedback circuitry. It increases efficiency, is lighter, smaller reliable VARIABLE LOW-PASS FILTER: A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use the Low-pass filter to primarily keep high notes out of your subwoofer(s) HIGH LEVEL INPUTS: Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the BAB10 to your factory radio or an …

Membrane diameter: 165 mm Capacity: 180/90 Watt RMS/Max Impedance: 4ohm Mounting Depth: 63 mm

Fully maximized Sealed motor structure UV resistant one-piece cast-polymer baskets Sealed magnet & rubber surrounds Polypropylene cone

Aluminum rear link plate 10-inch Front ABS / Steel reinforced port link Center link stabilizing dowels Alpine logo plate All hardware included

Hertz EBX 200.5 Subwoofer Bass Box Brand: HERTZ Product type: SPEAKERS

100 watts RMS 300 Watts Maximum Impedance 4 Ohm 16.5 cm SPL 90db 1 W 140 mm, 42 mm/1 m frequency response: 35 Hz – 21 kHz EÖ: Woofer Tweeter et: 47 mm, 14 mm woofer tweeter

Active thin-mount CompRT Subwoofer paired with passive ReFLEX sub for deep bass CompRT features Forced-Air Cooling - 20% cooler for increased reliability Compact enclosures with tough MDF construction for behind or under the seat

Spoked Subwoofer Grille designed for Kicker Comp,CompVT, CompVR, CompVX, and Solo Classic subwoofers series Simple installation Stylish black metallic finish Protects exposed Subwoofer from potential damage Dimensions: 10" (25cm)

Affordable big-bass performance - without taking up lots of room in your trunk or cargo area. Tough as nails. Load your cargo right on top of the sub for extra space – with plenty of bass! Full perimeter venting and UniPlate back plate and pole piece Stiff, injection-molded cone with 360-degree back bracing Utilizes extensive internal bracing, thick MDF construction and custom embroidery