Skil 1841 AA (F0151841AA)
Diamond Core Bits & Milling Cutters2284
 |
These are made from a single piece of High Speed Steel, ground with a very fine edge. They are only suitable for non abrasive materials, but will give a superior finish in soft timbers. Generally more→HSS cutters are slightly less expensive than their TC grades, but can be more suitable for certain applications. Suitable for general grooving and rebating. Specifications • Shank Diameter: 1/4 • Dia Metric: 6.3 • Dia Imperial: 1/4 • Cut Length Metric: 28 • Overall Length Metric: 59
 |
Cuts groove for Trend Routaseal. Position seal into apex of jamb and stop. More economic to use than more complex seals. Use with a small 1/4 inch shank hand router. Use STC for abrasive material. more→Specifications • Shank Diameter: 1/4 • Dia Metric: 5 • Cut Length Metric: 3 • Overall Length Metric: 61 • Angle: 115
 |
To suit user preference, the table shows angles from the horizontal and the profiles show angles from the vertical. Specifications • Shank Diameter: 1/4 • Dia Metric: 15.1 • Dia2 Metri more→c: 14.5 • Cut Length Metric: 13.7 • Overall Length Metric: 55 • Angle: 104
 |
TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. Two flutes give a clean finish to cut edges. Has a TCT plunge centre tip. Specifications • Shank Diam more→eter: 1/2 • Dia Metric: 10 • Dia Imperial: 25/64 • Cut Length Metric: 25 • Overall Length Metric: 71
 |
Scribing cutter to suit glazing bar ovolo. Designed for sash bar window construction. Specifications • Shank Diameter: 1/4 • Dia Metric: 25 • Cut Length Metric: 20 • Overall Lengt more→h Metric: 48.6 • Radius 1 Metric: 10
 |
1/4" Groove 19mm x 90° TCT Router Bit Contents 1 x TCT Router Bit, 1/4" Groove 19mm x 90°
 |
Profiler with shank mounted bearing guides. For use with router mounted above or below a table when following a template. For profiling and rebating applications only. Not for plunge cutting/groo more→ving. A 3mm maximum overlap should be left before trimming. They are ideal for template making. Specifications • Shank Diameter: 1/4 • Dia Metric: 9.5 • Dia Imperial: 3/8 • Cut Length Metric: 32 • Overall Length Metric: 74 • Bearing Dia Metric: 9.5
 |
TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. Two flutes give a clean finish to cut edges. Specifications • Shank Diameter: 1/2 • Dia Metric: 3 more→.2 • Dia Imperial: 1/8 • Cut Length Metric: 11 • Overall Length Metric: 56
Important!
Compatibility with specific Routers & Trimmers models should be checked with manager of online store immediately before purchase.
Compatibility with specific Routers & Trimmers models should be checked with manager of online store immediately before purchase.
