Hotpoint-Ariston CLAS B EVO 24 FF 24 kW (3300612)
 | Outdated Product Energy source: gas; Installation: wall; Type: dual-circuit (heating and DHW); Heating area (m²): 192; Built-in water heater tank; Heat output (kW): 24; Coolant min. T (°C): 35; Coolant max. T (°C): 85; DHW min. T (°C): 40; DHW max. T (°C): 65; Performance (ΔT=25 °C) (L/min): 22.8; Control bus: Bus BridgeNet |
 |
|
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Before buying always check characteristics and configuration of product with online store manager
Catalog Hotpoint-Ariston 2024 - new products, best sales and most actual models Hotpoint-Ariston.
Gas boiler for almost instantaneous supply of hot water to the faucet
Hotpoint-Ariston CLAS B EVO 24 FF has a closed chamber with forced smoke removal. Therefore, this boiler can be installed in a bathroom or kitchen, a separate room is not required. Its power (24 kW) is enough for simultaneous heating and hot water supply of a large apartment or medium-sized house. Inside it is installed a two-section indirect heating boiler with a total volume of 40 liters (20 L + 20 L). This volume is considered small. When operating in summer mode, the automation constantly maintains the secondary heat exchanger in a heated state, and hot water comes out of the tap immediately after it is opened.
Good power and fast response
This boiler has good performance (the ability to quickly heat water). The electronically controlled burner with flame modulation gives a fast response, instantly increasing power when the tap is opened. In the basic configuration, the heating temperature is controlled manually. But it can be fully automated (you need to buy sensors for the street and the room), if you want to create a "smart home" system.
The best option for apartments in new buildings
Hotpoint-Ariston CLAS B EVO 24 FF is perfect for installation in an apartment where a small family of 2 – 3 people lives. Ariston boilers are reliable and safe. They work perfectly even with reduced gas pressure in the line. But it should be noted that the electronics of this device is quite sensitive and does not like power surges in the network. Therefore, in old buildings with poor wiring, the boiler should be connected through a stabilizer, otherwise it will often turn off due to a tripped protection.
