Max. shredded material diameter
The largest thickness of debris that the shredder can handle normally. This parameter will allow you to evaluate how a particular device is suitable for a particular situation.
Note that the maximum diameter of the crushed material is important for models that allow working with branches (see "Chipping"). But in specialized aggregates for leaves, it is usually not indicated at all: the thickness of the garbage processed in such grinders is, by definition, small, and creating a design that works normally with any “soft” materials is usually not a problem.
Material throughput
The maximum amount of material that the shredder can process per hour. Note that in this case, the possibilities for perfect conditions are usually indicated: homogeneous garbage fed evenly, no interruptions in work, maximum speed (see “Adjusting the speed of the shredder”), etc. In addition, for universal models (see "Crushing"), the throughput is usually indicated for the most "convenient" material — leaves. Nevertheless, this parameter quite clearly characterizes the performance of the grinder.
It is worth choosing a model for throughput taking into account the volume of the proposed work. At the same time, it does not fit to take a certain margin, but it should not be too large — after all, high performance requires appropriate power, which, in turn, affects the dimensions, weight, price and "voracity" of the unit. Specific recommendations on optimal performance values for different situations can be found in special sources.
Shredder speed
The speed of rotation of the cutting tool of the chopper (see "Crushing system"). Variable speed models (see below) usually have a maximum RPM value.
In general, the general pattern is as follows: with equal engine power, the higher the speed, the lower the torque (see below), and vice versa. In addition, high speed improves performance (see "Bandwidth"). At the same time, this parameter in most cases is more of a reference value than a practically significant one: manufacturers select the rotation speed in such a way that it provides the claimed throughput and at the same time maintains the torque at a sufficient level for efficient processing of materials that were originally calculated design. Therefore, in some models, revolutions may not be indicated at all, and when choosing, it is worth focus on moments that are closer to practice.
Waste container capacity
The capacity of the garbage collector provided in the design or delivery set of the grinder.
The larger the container, the more recycled material the collector can hold and the less often it will have to be emptied. On the other hand, it is not always convenient to carry a large amount of material, and a large container takes up a lot of space — and if for soft bags (see "Type of collection") the latter is relevant only when fully loaded, then rigid containers are bulky by definition. Therefore, when choosing, you should proceed from the optimal compromise between capacity and convenience.
Overload protection
Availability
of protection against an overload in a design of a grinder.
Overload is a critical increase in the load on the working mechanism and, accordingly, the engine of the device. Such a situation may arise, for example, when too large or solid debris (or too many “regular” materials) enters the unit; at best, its consequences are limited to increased wear, at worst, an accident can occur. The protection system prevents such troubles by shutting down the motor (or the drive to the grinding system) in the event of an overload. Of course, you can also turn off the unit manually — however, automation is more reliable, since it constantly monitors the status of the device and reacts almost instantly.
Weight
The total weight of the grinder. Usually, in this case, only the weight of the unit itself is indicated — i.e. with an empty collector (for models equipped with standard tanks, see "Type of collector"), without fuel in the tank (for internal combustion engines, see "Engine type"), etc.
