Application class
The application speed class that the memory card corresponds to.
When working with applications that use a memory card (for example, mobile games), information is written and read not in a continuous stream, as when recording video or copying data, but in separate small fragments, moreover, from random sections in the memory of the drive (the so-called random write / read). So a high video recording class (see above) does not always mean good performance when working with demanding games and other resource-intensive programs. Therefore, in the characteristics of memory cards, they began to separately indicate the speed class for applications.
The key indicator for assigning one or another class is the minimum number of IOPS (input / output operations per second) that the media can provide in random write and read mode. The following classes are relevant today:
—
A1 — at least 1500 IOPS for reading and 500 IOPS for writing;
—
A2 — at least 4000 IOPS and 2000 IOPS, respectively.
The speed of continuous recording (for example, when shooting video) in both cases must be at least 10 MB / s (often it turns out to be even more — see “Speed class”, “Video recording class”).
In the future, we can expect the appearance of new, more performant classes for applications. Also note that this parameter significantly affects the price of the card.
Speed value
Factor describing the maximum speed of the card in read mode. In this case, 150 KB / s is taken as a unit; thus, for example, a speed value of 533x corresponds to 150 * 533=79,950 KB / s, that is, about 80 MB / s.
In general, this parameter is quite specific; in fact, it is easier to focus on the directly claimed reading speed (see below). However, sometimes it is not indicated — in such cases, the speed value will be primarily useful.
Read speed
The maximum speed of reading data from a memory card.
Any modern memory card provides sufficient reading speed for simple everyday tasks — like copying photos from a camera to a laptop. Therefore, it makes sense to pay attention to this parameter mainly in cases where the card is purchased for professional use, or if high speed is critical for you — for example, if you often have to copy photos from the camera in a hurry. In doing so, two points should be taken into account. Firstly, the corresponding speed must be supported by the card reader where the card is used. Secondly, this paragraph indicates the theoretical maximum — in perfect conditions; the actual reading speed may be lower (if we are talking about cards with UHS, this speed can be estimated by the UHS class, see above about it). Nevertheless, it is quite possible to compare different models of cards by this indicator: differences in theoretical speed usually quite correspond to the difference in actual speed.
Write speed
The maximum speed for writing data to a memory card.
High write speed is important for tasks that involve storing large amounts of data in a limited amount of time. However, note that this paragraph indicates the theoretical maximum speed for perfect conditions; in fact, this value can be noticeably lower. Therefore, the characteristics of memory cards also indicate the minimum guaranteed write speeds in different modes — the general speed class, the UHS class, the video recording class and/or the class for applications. All of them are described in more detail above. However, you can also evaluate the capabilities of the carrier by the overall speed: other things being equal, a card with a higher theoretical speed will work faster in fact.
As for specific values, speeds
from 4 MB / s and
from 6 MB / s are practically not found nowadays,
from 10 MB / s and from
16 MB / s can be called average indicators,
from 50 MB / s — above average, and the fastest models have a maximum write speed of
100 Mbps or more.
/depending on configuration/
