The temperature range for which the external temperature sensor of the weather station is designed (see "Measurements"). This parameter must correspond to the temperature differences that this sensor may be exposed to during operation — otherwise, malfunctions and even hardware failures are possible. Of course, it is worth choosing a model according to external temperature, taking into account the climate in which it is planned to be used; at the same time, it is worth taking a certain margin both in the lower and in the upper side. The last is connected not only with the possibility of climatic fluctuations, but also with the fact that outdoor equipment can be heated from direct or reflected sunlight; this, of course, must be avoided in every possible way, but it is not always possible to find an perfect fitting location for the sensor.
External representation of the weather station allows you to better fit the model into the interior of the room according to your preferences and taste. Among the models are
square and horizontal of two types —
horizontal and
vertical.
The main material used in the design of the weather station body (in models with a remote sensor, it usually uses the same material as the main unit).
—
Plastic. This cost-effective material is not only easy to process but also chemically inert, resisting corrosion, and has low thermal conductivity — a crucial feature for external sensors, minimizing the risk of hypothermia or overheating. While many plastic grades in modern electronics are weaker than the metal described below, this strength is generally sufficient for the typical operating conditions of weather stations. Consequently, this option is widely adopted, spanning all classes of weather stations, from budget-friendly to professional-grade.
—
Metal. Metal stands out for its superior strength, surpassing other materials and lending a stylish and robust appearance to the device. However, its higher cost makes it more common in high-end professional weather stations, prioritizing maximum strength and reliability. While metal may be used in analog models for aesthetic reasons, practical advantages are often secondary in such cases.
—
Glass. Glass, alongside wood, is a "designer" material employed in analog models. However, its impracticality arises from sensitivity to shocks and its relatively high cost. Consequently, this option is reserved for devices where original design is param
...ount, and even then, it is rarely chosen.
