Dark mode
United Kingdom
Catalog   /   Camping & Fishing   /   Fishing   /   Boat Motors

Comparison Parsun TC3.6BMS vs HDX T3.6CBMS

Add to comparison
Parsun TC3.6BMS
HDX T3.6CBMS
Parsun TC3.6BMSHDX T3.6CBMS
Outdated ProductOutdated Product
TOP sellers
Applicationboatboat
Motor typepropellerpropeller
Motor
Engine typepetrolpetrol
Motor duty cycle2-stroke2-stroke
Maximum power3.6 hp3.6 hp
Maximum power2.69 kW2.64 kW
Maximum revolutions5500 rpm5300 rpm
Number of cylinders1 pcs1 pcs
Capacity75 cm375 cm3
Piston diameter47 mm47 mm
Piston stroke43 mm43 mm
Coolingliquidliquid
Exhaust systemthrough the propellerabove propeller
Fuel system
Fuel system typecarburetorcarburetor
Fuel tankbuilt-inbuilt-in
Fuel tank volume1.5 L1.5 L
Recommended fuelAI-98 gasolineAI-95 gasoline
Drive unit
Gear ratio2.082.15
Propeller screw3-bladed3-bladed
Left rotation of the screw
Gear
forward
neutral
forward
neutral
Equipment
Transom height (deadwood)381 mm381 mm
Control systemtillertiller
Launch typemanualmanual
Leg lift (trim)manualmanual
General
Weight16 kg13.5 kg
Added to E-Catalogjanuary 2017june 2015

Maximum power

The maximum operating power of the outboard motor, expressed in kilowatts.

The practical value of motor power is described in detail in “Maximum power" is higher. Here we note that the kilowatt (derivative of watt) is just one of the units of power used in fact along with horsepower (hp); 1 HP ≈ 735 W (0.735 kW). Watts are considered the traditional unit for electric motors (see "Engine Type"), but for a number of reasons, outboard motor manufacturers use this designation for gasoline models as well.

Maximum revolutions

The highest shaft speed that the outboard motor is capable of developing.

Theoretically, the speed of rotation of the propeller (or turbine — see "Motor type") depends on the engine speed, and, accordingly, the speed that the boat is capable of developing. However, in addition to this indicator, many other factors also affect the performance of the motor — engine power (see above), gear ratio (see below), propeller design, etc. As a result, situations are quite normal when a more powerful and high-speed motor has lower revolutions than the weaker one. Therefore, this parameter is, in fact, a reference one, and has almost no practical value when choosing. Unless it can be noted that high-speed motors are more susceptible to noise and vibration than low-speed ones; however, this moment can be compensated by the use of various technical tricks.

Exhaust system

The design of the exhaust system in a gasoline outboard motor (see “Engine type”), more precisely, the method of exhaust gases used in this system.

Above the screw. This category includes two types of engines. The simplest option is when exhaust gases are emitted directly into the air. Such systems are extremely simple and cheap, but the exhaust can create a noticeable inconvenience for people in the boat (not only because of the gases, but also because of the rather high noise level); therefore, they are found only in the simplest outboard motors, and even then quite rarely. A more common option is to release exhaust gases into the water above the propeller (most often through the so-called anti-cavitation plate — a flat ledge above the propeller). Such systems are more comfortable than "air" ones, while they are simpler and cheaper than propeller exhaust (see below), although they are still considered less technically advanced.

Through the screw. In systems of this type, the exhaust is led into the water directly through the propeller hub; in fact, the position of the exhaust pipe coincides with the axis of rotation. This reduces the noise level compared to systems using exhaust over the propeller, and also slightly increases power and traction characteristics. The downside of these advantages is the design complexity and, accordingly, the high cost.

Recommended fuel

The type of gasoline recommended for use in an internal combustion engine outboard (see "Engine Type"). In fact, this paragraph indicates gasoline with the lowest octane rating that is allowed to be used in the engine; higher rates are allowed, lower ones are highly undesirable, if not outright prohibited.

The octane number is an indicator that determines the resistance of a particular brand of gasoline to detonation (self-ignition during compression in the cylinder). Detonation is a very undesirable phenomenon, because. it leads to an increase in engine loads simultaneously with a decrease in its power and an increase in the amount of harmful substances in the exhaust gases. And this phenomenon occurs in cases where the engine uses gasoline with lower octane numbers than those for which the unit is designed.

Automobile gasoline, which is also used for refueling boat engines, is marked with the AI or RON index; the first option is used in the characteristics of east european motors, the second — in foreign ones. However, in both indexes, the number after the letters means the octane number. The higher this number, the more demanding the engine is on fuel quality. Thus, for example, a unit under AI-92 will be able to work normally with AI-95, but AI-90 or AI-87 cannot be filled into it. "Record holders" for unpretentiousness today are engines that can work even on the AI-76; but they are a rare exception to the general rule.

Gear ratio

The gear ratio describes how fast the propeller of the outboard motor rotates relative to the speed of rotation of its shaft. For example, a gear ratio of 2 means that for each revolution of the shaft, the screw, in turn, makes two revolutions (that is, it rotates twice as fast). In modern outboard motors, this parameter, in fact, is purely reference, because. the practical characteristics of the unit (power, traction, etc.) depend on many design features and are practically not related to the gear ratio.

Left rotation of the screw

The direction of rotation of the propeller is determined by the direction in which it rotates in forward motion, when looking at the ship from the stern. Clockwise rotation is called right, counterclockwise — left.

Most modern outboard motors have a right-hand rotation propeller — this option is standard for boats with a single engine. But if there are two engines, they must have rotation in different directions — otherwise the ship will constantly pull to the side with a straight steering wheel. For such cases, units with a left-hand rotation of the propeller are produced — they are practically not used independently and are mainly intended for installation in tandem with right-hand rotation motors.

Weight

The total weight of the outboard motor. This parameter is indicated, usually, only for the unit itself, without taking into account the fuel in the tank and the tank itself (if it is external, see "Fuel tank"), as well as additional equipment. Motor weight data can be useful in order to estimate the overall balance of the boat and the change in its payload capacity.
Parsun TC3.6BMS often compared