Suction width
Suction width provided by the unit. It is indicated mainly for floor scrubbers and window vacuums (see "Type"). In the first case, it refers to the width of the suction beam; in the second — the width of the working nozzle.
The width of the suction beam in scrubber dryers is usually slightly larger than the overall working width — it allows one to collect the water used in cleaning effectively. The size of the suction beam in some models of this type reaches 75 cm. In turn, in window vacuum cleaners the suction width corresponds to the actual working width. Most often, this figure is about 28 – 29 cm. it is believed that such values give an optimal ratio between performance and dimensions/weight of the unit. However, there are also more miniature models — in some devices, the width of the nozzle does not exceed 17 cm.
Additional nozzle
The width of the additional nozzle provided with the device.
Additional attachments are mainly supplied with window models (see "Type"). Such a nozzle is usually made narrower than the main one — it makes it easier to work on small glasses and in hard-to-reach places. However, there is also the opposite option: a small capture width in the device itself, increased by using an additional nozzle.
Waste detergent tank
Объем бака для отработанного раствора, установленного в уборочной машине.
Такими баками оснащаются исключительно поломоечные машины (включая бытовые) и модели для окон (см. «Тип»): напомним, и те, и другие рассчитаны на всасывание раствора с обрабатываемой поверхности. В целом чем вместительнее бак — тем реже придется его опорожнять, однако тем больше будут габариты и вес агрегата. Поэтому производители обычно выбирают данный показатель с учетом типа и особенностей применения машины. Так, в устройствах для окон, которые при работе удерживаются в руках на весу, вместимость баков под отработанный раствор невелика — обычно порядка 150 – 200 мл; этого вполне достаточно с учетом формата применения и в то же время такой дополнительный вес не создает неудобств при работе. В свою очередь, в поломоечных машинах применяются емкости на несколько литров или даже десятков литров; как правило, конкретный объем напрямую зависит от общей «весовой категории» и производительности машины.
Battery capacity
The capacity of the battery installed in the cleaning machine with the appropriate power supply.
Theoretically, a higher capacity allows you to work longer on a single charge, but everything is not so simple. Firstly, battery life is also affected by the power consumption of the machine, and it is determined mainly by the motor power (see above). Secondly, the actual amount of energy stored in the battery depends not only on the capacity in amp-hours but also on the operating voltage in volts. Therefore, only batteries with the same voltage can be compared with each other in terms of capacity in Ah (or convert ampere-hours to watt-hours using a special formula and compare the results). And it is best to evaluate the battery life of the unit according to the directly claimed autonomy time (see below).
Charging time
The time required to fully charge the battery of cleaning machine (see "Power supply").
The larger the battery, the longer it may take to charge it. On the other hand, this moment also depends on the type of battery. In addition, special technologies are being used to speed up the process. So two machines with a similar battery capacity can differ in charging times.
Weight
The total weight of the cleaning machine. Usually, weight is indicated with empty tanks for detergent, waste, fuel, etc. At the same time, additional equipment, such as side brushes, may or may not be taken into account. Such equipment has a very small weight compared to the machines themselves. And, when installed/removed, does not seriously affect the mass of the entire machine.
