Dark mode
United Kingdom
Catalog   /   Climate, Heating, Water Heating   /   Water Supply & Pumps   /   Surface Pumps

Comparison Aquatica ACm150B4 vs Aquatica ACm150B3

Add to comparison
Aquatica ACm150B4
Aquatica ACm150B3
Aquatica ACm150B4Aquatica ACm150B3
from $222.59 up to $246.40
Outdated Product
from $207.04 up to $229.20
Outdated Product
TOP sellers
Suitable forclean waterclean water
Specs
Maximum performance60000 L/h60000 L/h
Maximum head15 m14 m
Pump typecentrifugalcentrifugal
Suction height8 m8 m
Maximum liquid temperature60 °С60 °С
pH value6.5 – 8.56.5 – 8.5
Suction systemsingle-stagesingle-stage
Outlet size4"3"
Inlet hole size4"3"
Engine
Maximum power1500 W1500 W
Power sourceelectricelectric
Mains voltage230 V230 V
Engine typeasynchronousasynchronous
Power cord length1 m1 m
General specs
Protection class (IP)X4X4
Country of originUkraineUkraine
Pump housing materialcast ironcast iron
Impeller / auger materialbrassbrass
Dimensions393x230x295 mm386x230x295 mm
Added to E-Catalognovember 2014november 2014

Maximum head

The maximum head generated by the pump. This parameter is most often indicated in meters, by the height of the water column that the unit can create — in other words, by the height to which it can supply water. You can estimate the pressure created by the pump using a simple formula: every 10 m of head corresponds to a pressure of 1 bar.

It is worth choosing a pump according to this parameter, taking into account the height to which it should supply water, as well as adjusting for losses and the need for pressure in the water supply. To do this, it is necessary to determine the difference in height between the water level and the highest point of water intake, add another 10 to 30 m to this figure (depending on the pressure that needs to be obtained in the water supply), and multiply the result by 1.1 — this will be the minimum pressure required.

Outlet size

The thread size for connecting a hose or pipe to the pump outlet. If there is a branch pipe with an external thread in the design, the size is indicated for it; if not, for the internal thread of the inlet.

Anyway, the dimensions of the pump outlet and the mounts on the hose/pipeline connected to it must match — otherwise, you will have to look for adapters. This size is specified in inches and fractions of an inch.

This parameter is relevant primarily for surface models.

Inlet hole size

The size of the thread designed to connect the pump to the suction line. This parameter is completely similar to the size of the outlet (see above) — in particular, it can be specified both for the nozzle and for the inlet of the pump.