Welding slat length
The length of the welding slat for sealing bags provided in the vacuum sealer. In fact, this is the
maximum seam length that the device can create; the size of the open side of the package should not exceed this length, otherwise it will not be possible to vacuum and seal the package normally. If bags in rolls are used for packaging, the length of the welding slat corresponds to the maximum width of the roll. And powerful industrial models have large slats on which several packages can be placed at once.
Pumping speed
Air pumping speed provided by the vacuum sealer.
The
higher the speed, the less time it will take to operate the device. In addition, "faster" models tend to be more powerful and can deliver deeper vacuums. On the other hand, in normal household use, these points are not critical, and when choosing a "home" sealer, you can not pay much attention to the pumping speed — unless you have to regularly pack large volumes of products, or storage time is crucial.
Suction power
Suction power provided by the vacuum sealer.
This parameter directly characterizes the capabilities of the device to create a vacuum. Suction power is the difference between normal atmospheric pressure (1 bar) and the lowest pressure that this model can create inside the package. For example, a figure of 0.8 bar means that the packer can create a pressure of 1 – 0.8 = 0.2 bar. Accordingly, the higher the number in this point, the more powerful the sealer, the deeper the vacuum it creates.
In general, if the products are packed at home for relatively short storage (or vacuuming is combined with freezing), this indicator can be ignored. But for professional use, high suction power is fundamental.
Power consumption
Rated power consumption of the device. Usually, the characteristics indicate the average power in normal operation; peak values can be much higher, but this mode does not last long.
On the one hand, the efficiency and speed of vacuuming directly depend on the power consumption, on the other hand, the consumption of electricity. And heavy high consumption industrial-grade devices may require a three-phase connection (see "Power supply").
