Comparison Sharp SJ-BA05DMXL1 stainless steel vs Liberton LRD 180-280

The total capacity of the refrigerator is the total capacity of all the main working chambers: refrigerating, freezing, zero, and wine chambers. The set of these chambers, of course, will be different in different models (see more about them above). Here we note that large volumes, on the one hand, simplify the storage of numerous products and, on the other hand, affect the dimensions and price of the unit. It is also worth considering that refrigerators of the same total capacity may differ in the capacity of individual chambers.

The refrigeration circuit can be described as a heat sink system that has a separate connection to the compressor (see “Number of compressors”) and a separate, independent from other similar systems, regulation of the operating mode.

In the most common variety of modern refrigerators — two-chamber models with a freezer — both one common circuit for both chambers and 2 circuits can be provided. The second option is more expensive, but it gives an important advantage — in such refrigerators, you can completely independently control the operating modes of the refrigeration and freezer compartments. If there is only one circuit, these adjustments turn out to be interconnected: for example, when you turn on the fast freeze mode (see "Features"), the main chamber also starts to work at increased cooling power, which is not always desirable.

As for refrigerators with three or more chambers, usually, the number of circuits in them is less than the number of chambers — otherwise, the design would be unnecessarily complex, cumbersome and expensive.

The total capacity of the main working chamber of the refrigerator. If there are separate zero chambers, compartments for wine and other additional functions, this paragraph takes into account only the volume of the refrigerating chamber itself, without additional equipment. In the smallest modern units, this figure does not even reach 100 liters, in the largest it can exceed 400 liters.

The choice of capacity depends on the actual storage needs of the products. At the same time, both the volume of stocks and the frequency of their replenishment (every day, once a week, etc.) matter. The chamber should not be stocked completely; this adversely affects the quality of the refrigerator. On the other hand, it is worth remembering that large volumes accordingly affect the dimensions and price of the unit.

In general, for one or two people, a capacity of 200 – 250 liters, or even less, is considered quite sufficient. The optimal capacity for a family of three is about 250 – 300 liters, for four to five people — 300 – 350 liters, and larger volumes are really needed mainly for specific situations when food has to be stored in large quantities and for a long time.

Forced cooling mode, in which the intensity of cooling the refrigeration compartment is significantly increased. It is an analogue of the fast freeze described above, used in the refrigerator compartment. Fast cool is also intended mainly for situations where a lot of foodstuff must be loaded inside at a time — it avoids a critical increase in temperature inside the refrigerator. This mode also needs to be turned on in advance and turned off after a certain time. In some models, the shutdown occurs automatically, but the presence of this feature needs to be specified separately.

The capacity of the freezer installed in the refrigerator. Such a chamber is designed to store products at temperatures well below zero (on average -18 °C). Its capacity is related to the total capacity of the refrigerator (and the capacity of the main, refrigerating chamber). However, there is no strict dependence here — models with a similar volume of the refrigerating chamber can be equipped with freezers of different sizes.

When choosing by capacity, it is worth considering how much frozen food you plan to store at a time. Note that it is undesirable to fill the freezer completely — this negatively affects the efficiency of work. However, if this chamber is planned to be used only occasionally, and you do not plan to keep numerous products in it, you can not chase after the capacity: for such cases, 25 – 50 liters, or even smaller capacities, are enough. In the smallest modern refrigerators, the freezer capacity does not exceed 10 liters. And vice versa, very roomy freezers come across — for 176 – 200 liters and even more. Such volumes are typical mainly for side-by-side and French door units (see "Product type"). However, they are also found in models of the classic two-chamber layout.

The autonomy time provided by the refrigerator when the power is turned off.

Often, this parameter describes the capabilities of the freezer. In such cases, the autonomy time is indicated as the time during which, at an outside temperature of +25 °C, the temperature in the filled freezer does not rise above -9 °C (this level is considered critical for the storage of frozen foods). Accordingly, the actual autonomy time may differ from the claimed one — depending on the ambient temperature, the frequency of opening the refrigerator, etc. However, this parameter describes the quality of thermal insulation quite accurately, and it is possible to evaluate different models and compare them with each other.

Also, autonomy time can be given for models without freezers: in such cases, we are talking about the time during which the temperature in the refrigerator compartment remains at an acceptable level under approximately the same conditions.

The average amount of energy consumed by a refrigerator in a year of operation. Of course, these figures are not absolutely accurate; the actual power consumption may vary depending on the specific operating conditions. However, this parameter makes it possible to evaluate the power consumption of the refrigerator and compare different models with each other. At the same time, it often turns out to be more convenient and visual than the energy consumption class (see above) because in this paragraph we are talking about a specific figure (from which you can also calculate the cost of electricity consumed). For clarity, let's take the following example: a small two-chamber refrigerator with energy class A can consume less energy per year than a large side-by-side unit of class A+++, although formally, in terms of energy consumption classes, the second model will be more economical than the first.

The average noise level generated by the refrigerator during operation.

The quietest models of refrigerators are noisy at a level of about 30 dB — this volume is comparable to the whispering or ticking of a wall clock and does not exceed the sanitary standards for residential premises at night. In other words, such a unit will not interfere with sleep, even if it is placed right in the bedroom. At the same time, the standard place for a refrigerator is still a kitchen, and with such an installation it is isolated from other living quarters. Therefore, the noise of 40 – 42 dB, corresponding to a quiet conversation, is considered quite acceptable for ordinary household refrigerators. And with good sound insulation, a volume of up to 50 dB is allowed — this is the level of conversation at an average volume.

Higher values are rare among refrigerators and are mainly found in display refrigerators(see "Product type") installed in shops where noise levels are not as much important.

The country in which this refrigerator model is manufactured (according to the manufacturer).

There are many stereotypes associated with the relationship between the origin and the quality of household appliances. Thus, the location of production in Europe ( Germany, Lithuania, Poland, Romania, Serbia, Turkey, etc.) is considered more prestigious than in Asian countries ( China, Thailand) or CIS countries ( Belarus, Russia, Uzbekistan, etc.). And different European countries have a different reputation among buyers in this regard. However, these stereotypes should be treated with considerable distrust: the actual quality of products depends not so much on the geography of production, but on the quality of the organization of processes by a particular manufacturer. As a result, equipment of a similar level, produced by different brands in the same country, may differ markedly in actual quality.

It is worth to say that the same refrigerator model can be produced in several countries at the same time. And units of the same model, produced at different times at different plants, may be on the market at the same time. As a re...sult, it happens that one country of production is indicated in the general characteristics of the model and another in the documentation for the unit purchased. It is quite a normal situation. However, if the country of production is still important for you, you should clarify this point in advance before buying.