Drying type
— Condensing (recuperative) The general principle of
condensation drying is as follows: heated air is passed through the laundry drum, captures moisture, and then enters the refrigerator, cools down, and excess moisture condenses in a special tank. The advantage of all condensing machines over
air vented ones is that they are easy to install. They do not need to be connected to ventilation and can be installed in any room. On the other hand, the user needs to monitor the condensate tank and periodically drain the accumulated water. And such units are somewhat more complicated and more expensive than ventilated ones. However, recuperative dryers are the simplest and most inexpensive among condensing dryers. By the name, the role of a refrigerator in them is played by a recuperator: a heat exchanger that dumps excess heat into the outside air. The heating of the air inside is usually carried out using a heating element. Due to their availability, such machines are very popular, but they have serious drawbacks. Firstly, devices of this type have high electricity consumption. Secondly, the efficiency of their work is relatively low. Moreover, it directly depends on the temperature difference between the air outside and inside the dryer.
—
Condensing (heat pump drying). The most advanced and most expensive type of condensing dryer. See above for more information on conde
...nsing drying in general. Note that in models of this type, the refrigerator operates due to a heat pump — a compressor that takes excess heat from the condensation chamber and transfers it to the heater. It provides several advantages over traditional recuperative drying. One of the most noticeable is high efficiency and economy: the heat pump allows you to reuse the accumulated thermal energy, and less electricity is spent on its operation than on the constant air heating in recuperative models. In addition, drying is easier and faster, and the work speed is practically independent of outdoor conditions. And such a machine almost does not produce excess heat. The disadvantages of models with a heat pump are traditional — complexity and high cost.
— Air vented. A kind of drying in which excess moisture is blown out of the machine into the outdoor space. Compared to condensing drying, this option allows you to create simpler, cheaper and more compact units. And such models are somewhat easier to use because they do not require monitoring the water level in the condensate tank. On the other hand, installing a ventilated machine is noticeably more difficult. So, in the room where the unit is located, there must be a powerful ventilation system, otherwise, there will always be high humidity and temperature. Such a microclimate is not only harmful to people and furniture but also significantly worsens drying efficiency. If it is impossible to organize general ventilation for the room for one reason or another, one will have to make a separate air duct to remove steam from the dryer. As a result, this type of drying is considered inconvenient and extremely rare.Drum volume
The internal volume of the dryer drum.
A
larger drum can accommodate more laundry, but there is no rigid dependence here: models with the same volume may differ in maximum load. It is because to process a large mass of laundry, one need not only a capacious drum but also an engine of appropriate power. At the same time, in a larger drum, the same mass of laundry will dry more efficiently than in a small one, because laundry will be more freely distributed over the drum, crumpled less, and warm air will better penetrate the folds of the fabric. As a result, for the same drum volume, a model with a smaller load will be more efficient and performant than a model with a larger load. On the other hand, a volumetric drum takes up more space and the dimensions of the dryer are largely determined by the dimensions of the drum.
Number of drying programmes
The number of preset drying programmes. Such programmes are often optimized for a specific type of fabric: linen, silk, synthetics, etc. The more drying programmes, the more versatile and easier the dryer is to use. However, a specific set of modes in different models may be different, and even a large variety of programmes does not guarantee that one of them will be suitable. So before buying, it is advisable to specify not only the quantity but the list of claimed programmes.
Moisture sensor
Ability to choose the residual moisture content of the linen to be dried - from completely dry, which can be immediately put in the closet, to slightly dry, which is optimal for ironing. With
laundry moisture control, the user needs to select the desired residual moisture - the dryer will automatically control the condition of the laundry and stop drying at the right time.
Quick dry
Quick dry programme that dries in a relatively short time. It saves time, but the laundry wears out more than during normal drying and is not suitable for delicate types of fabric.
Condensate tank volume
Only condenser dryers have such a tank (see "Drying type"). The larger the tank, the less often you have to get rid of the accumulated liquid. At the same time, in most models, the volume of the condensate tank is standard — about 5 – 6 litres: this is considered the best compromise between capacity and dimensions.
Drying class
Drying class describes the overall drying efficiency that the machine provides. It is denoted by a Latin letter, where A is the best efficiency, and further in decreasing order (
drying class B is inferior to
class A, but exceeds
class C). Naturally, higher efficiency machines cost more (ceteris paribus).
Energy class
The energy consumption class shows not the actual energy consumption but the efficiency of the dryer. In other words, what part of the electricity consumed goes directly to useful work. For dryers, this parameter is especially important because such devices have high electricity consumption. As a result, models with the same capabilities but different energy efficiency classes differ markedly in terms of operating costs (in terms of electricity bills). However, more economical units themselves are more expensive. nevertheless, this difference quickly pays off.
Initially, classes were marked in Latin letters from
A(the highest class) and further alphabetically. In the course of technology development, more economical levels of consumption than the original class A appeared — they are labelled as A+,
A++, A+++, etc. Actually, the highest efficiency class in modern dryers is exactly
A +++ ; level A —
A+ can be called good,
B — average, C — acceptable.
Noise level
The noise level generated by the dryer during operation. Usually, the specs indicate the maximum volume of the device, in the noisiest mode — when other programmes are running, this figure may be lower. We note that the noise level also depends on the features of the installation: for example, if the machine does not stand firmly on all four legs, vibration from drum rotation can create additional noise. And the tiled walls amplify the sound by creating an echo. Nevertheless, it is best to evaluate the device precisely by the noise level stated in the specifications. And here it is worth bearing in mind that the decibel used to denote loudness is a non-linear value, and it is best to evaluate the actual loudness of the unit using comparative tables. Here is the simplest such table for the volume range in which modern dryers operate:
65 dB — a person's voice in raised tones at a distance of 1 m;
70 dB — a loud conversation of several people at the same distance;
75 dB — loud laughter at a distance of 1 m;
80 dB — motorcycle engine, medium power vacuum cleaner.
The quieter the machine is, the more comfortable it will be to use and the better it will be suitable for a specific environment (for example, if there is a small child in the house or if you plan to run drying at night). At the same time, it is worth considering not only the actual noise level but also the installation location of the device. If the dryer is planned to...be installed in the basement of a private house with thick ceilings and the bedroom is located on the second floor, you can not pay much attention to the noise level: even the loudest unit is unlikely to create inconvenience.
