Comparison Mitsubishi Electric Lossnay VL-50S2-E vs Mitsubishi Electric VL-50ES2-E

Clear Table
Add to comparison
	Mitsubishi Electric Lossnay VL-50S2-E	Mitsubishi Electric VL-50ES2-E
	Outdated Product	Outdated Product
all specs only differences
TOP sellers	Find prices on Amazon.uk Find prices on eBay.uk	Find prices on Amazon.uk Find prices on eBay.uk
Main	Horizontal and vertical installation is allowed. Recuperator. Low power consumption. Quiet operation.	Air flow adjustment. Low noise. Horizontal and vertical mounting methods are allowed.
System type	decentralized	decentralized
Ventilation type	recuperator	recuperator
Mounting	wall	wall
Mounting diameter	120 mm	120 mm
Specs
Minimum air flow (recuperation)	15 m³/h	15 m³/h
Maximum air flow (recuperation)	51 m³/h	54 m³/h
Minimum noise level	14 dB	15 dB
Maximum noise level	37 dB	37 dB
Type of heat exchanger	plate	plate
Heat exchanger material	cellulose	cellulose
Heat exchanger efficiency	86 %	86 %
Minimum operating temperature	-20 °C
General specs
Remote control
Power consumption in ventilation mode	19 W	19 W
Mains voltage	230 V	230 V
Country of origin	Japan	Japan
Dimensions	522x245x168 mm	522x245x168 mm
Weight	6.2 kg	6.2 kg
Added to E-Catalog	april 2019	august 2018

Minimum operating temperature

The lowest outdoor air temperature at which the ventilation unit can be safely used; more precisely, the minimum inlet air temperature at which the unit can operate normally, without malfunctions, for an indefinitely long time.

It is worth choosing according to this parameter taking into account the climate in which it is planned to use the unit: the device should normally tolerate at least the average winter temperature, and it is best to have some reserve in case of a harsh winter. However, many modern models allow operation at -10 °C and below, and in the most cold-resistant ones, the temperature minimum can reach -35 °C. So choosing a unit for a temperate climate is usually not a problem. Also note that if an installation that is ideally suited for all other parameters cannot cope with low temperatures, the situation can be corrected by using an additional heater at the inlet of the ventilation system.

Note that if the minimum temperature is not indicated in the characteristics, it is best to proceed from the fact that this model requires a temperature not lower than 0 °C. In other words, in cold weather, it is worth using only the equipment for which this possibility is directly stated.