United Kingdom
Catalog   /   Tools & Gardening   /   Construction Power Tools   /   Tile Cutters

Comparison Intertool HT-0383 vs Intertool HT-0366

Add to comparison
Intertool HT-0383
Intertool HT-0366
Intertool HT-0383Intertool HT-0366
Outdated Product
from $34.56 up to $43.16
Outdated Product
TOP sellers
Typemanualmanual
Specs
Bore diameter10.5 mm
Cutting length750 mm600 mm
Cutter diameter22 mm22 mm
Max. tile thickness12 mm
Functions
Disc/cutter feedtoptop
Angle stop
 /0 – 60°/
General
Weight11 kg
Added to E-Catalogmarch 2019september 2015

Bore diameter

The diameter of the mounting hole on the cutting disc that the tile cutter is compatible with. This parameter is important when searching for and purchasing interchangeable working nozzles: the diameters of the mounting hole on the tile cutter and on the disk must match.

Cutting length

The longest cut that can be made with a tile cutter.

This parameter is relevant primarily for manual tile cutters, as well as for electric stationary units with a top disc feed. In such tools, the cutting element moves along the guide rail and has limited space for movement, and the length of the cut is, in fact, the length of the stroke of the cutting tool from one extreme point to the other. In fact, this is the maximum width of the material that can be cut with a tile cutter.

Max. tile thickness

Thickest tile thickness that a manual tile cutter can handle (see "Type"). Since in such tools the tile does not cut through, but breaks along a pre-drawn line, the characteristics do not indicate the depth of the cut, but directly the thickness of the material. This indicator is directly related to the pressure on the fault (see below). Also note that it is quite approximate — the actual capabilities of the tile cutter depend on the characteristics of the material from which the particular tile is made, as well as the physical form of the user.

Angle stop

The presence of an angular stop in the design of the tile cutter.

The miter fence is designed to make it easier to cut diagonals and other oblique lines. Do not confuse this function with angular cutting: in this case, we are talking about turning the material horizontally, and the cut itself can be normal, vertical. The corner stop is convenient because you can set it to the desired angle in advance, and then fix the tile in it and not worry about it moving during cutting. This is easier than holding the material by hand and controlling the angle in other ways.
Intertool HT-0383 often compared