Routers & Trimmers Trend

Two Flute Cutter for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. Two flutes give a clean finish to cut edges. All cutters above and including 9.5mm diameter, have TCT plunge centre tips.

Profilers with shank mounted bearings for guidance, for use with router mounted above or below a table when following a template. Bearing guided cutters are suitable for both straight and curved work. For profiling and rebating applications only. NOT for plunge, cutting or grooving. A 3 mm approximate overlap should be left before copy profiling, also when using plastic laminate always allow laminate adhesive to dry before trimming. This avoids clogging the guide bearing.

These staff bead are ideal for producing nosings and attractive edges. Edge cut only. Specifications: • Shank Diameter: 1/4 • Dia Metric: 20 • Dia Imperial: 25/32 • Cut Length Metric: 19.1 • Cut Length Imperial: 3/4 • Overall Length Metric: 57 • Overall Length Imperial: 2 1/4 • Radius 1 Metric: 5.2

Two flute straight plunging bits General-purpose tool suitable for profiling, rebating and through slotting. Plunge cut when on the move.

These dovetail cutters produce a tight reliable joint for drawers, boxes etc. efs. Can be used with Trend CDJ300, CDJ600 & DJ300 dovetail jigs. To suit user preference, the table shows angles from the horizontal and the profiles show angles from the vertical.

Two flute straight plunging bits General-purpose tool suitable for profiling, rebating and through slotting. Plunge cut when on the move.

Trend Two Flute Straight Cutters produce a cleaner finish than single flute cutters. Suitable for grooving, rebating, morticing, drilling and shallow lateral routing cuts such as recessing hinges. Corners will require a final trimming square with a hand chisel or a corner chisel. Suitable for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. This Trend 3/2 x 1/2 TCT Two Flute Cutter has the following specification D 6mm (15/64in) C 16mm OL 61mm Shank Diameter 1/2in

This Trend 334 x 1/2 TCT Aquamac 21 Recessor, cutter, is designed for use with the seal in a wiping mode and comes complete with a guide bearing to reduce setting-up time and simplify machining operations. It is MEC mechanical feed only. Specifications Size 46.3mm diameter x 10.3mm cut shank 1/2in TCT. D 46.3 mm. D2 4.3 mm. C 10.3 mm. C2 2.7 mm. OL 90 mm. B 28.6 mm.