Car Subwoofers

Flat Subwoofer / Nominal Load 130 Watt

V Cone with pressed paper membrane for maximum lightness High excursion foam surround combining high sensitivity and deep bass response Designed to be used in small sealed or reflex box ABS gasket provided for aesthetically pleasant installation Continuous 250 W power handling

Boss NEO12, 12" (30cm), Ripper Series, 300W RMS, 600W MAX, Impedancy: 4 ohms

Boxed Subwoofer / Diameter 270 mm / 11 Inch / 300 watt / Impedance 4 x 4 Ohm

Membrane diameter: 165 mm Capacity: 180/90 Watt RMS/Max Impedance: 4ohm Mounting Depth: 63 mm

Space Saver - The combination of amplifier and subwoofer all into one, makes this ideal for spatially challenged vehicles. With a slim design, there are a few installation options. Embrace the Bass. Built-in Amplifier - A built-in 800 Max watt amplifier powers the subwoofer Pulse Width Modulated - This design controls the output voltage and current precisely by not only removing the output current sensing loss, but also eliminating all secondary feedback circuitry. It increases efficiency, is lighter, smaller reliable Variable Low-Pass Filter - A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use the Low-pass filter to primarily …

No matter how you turn and turn it, you will always find a place for the Bassbox ATB120 from Car Audio Specialist AXTON. The hip flask with 20 cm subwoofer chassis and reflex channel fits with its practical dimensions 135 x 485 x 345 mm in almost any boot: be it flat on the floor or hidden in the double floor, firmly mounted on the side panel or on the rear seat back. AXTON's bass reflex subwoofers are perfectly matched to the purpose, case size, practicality and equippment. A powerful 20 cm / 8" woofer works in the sturdy housing construction: Equipped with a stiff fibreglass/paper sandwich membrane Fiberglass/paper cone with butyl rubber surround, the bass driver provides rich, sounding bass …