Recuperators & Ventilation Recovery

1 cabin BV100H-D with 2 axial fans 2 hoses of 2 meters x 10 cm, - 1 filter, - 1 power cord, - 1 instruction / warranty booklet Weight: 37 Kg Dimensions from open: 96 x 74 x 62 cm, - Suction section: 96 x 66 x 62 cm, - Material: Steel with gray finish Voltage: 230V 50 Hz, - Air intake: 710 cubic meters / hour, - Noise level: 60 dB

Air Flow - Full air flow control. Slide tray to access air flow dampers at any time. Easy Cleaning - Slide and remove tray for easy duct cleaning.

Large 12'' 300mm Industrial/Commercial Extractior Fan with Fixed Grille & Wall Kit Product type: ELECTRIC FAN

Home improvement - For Intake or extraction use, for outside or inside, for walls or ceilings, great for garages, sheds, offices, bathroom, RVs or campers, and anywhere else air is desired to travel through Premium material: Louvre air vents are made of new high quality non-rusty metal, environment friendly and non-toxic. Built-in fly screen mesh. Easy Installation - available for wall mounting or ceiling mounting. May be conneted to dryer vent or any other VENT SYSTEMS HVAC part Diameter for 5" Inch Opening. Grille diameter is 5.8''. Outside diameter is 6.46" - Ideal for room exhaust and intake ventilation use. Great and beautiful design. Reduce dust into kitchen or bathroom by fly screen …

The Vent-Axia Lo-Carbon Tempra SELV LP Single Room Heat Recovery Unit is available with Safety Extra Low Voltage, a constant trickle speed and with a pullcord or switch to boost airflow. The units are suitable for installation into external walls up to 460mm thick and all installations can be carried out from inside a building. To facilitate ease of maintenance and installation the Tempra's simple construction is not difficult to fit in the same location as an existing 100mm diameter fan and offers easy access to the heat exchanger for regular maintenance. Under the Building Regulations Document F, continuous running products such as the Lo Carbon Tempra are only required to move an amount of …

The Vent-Axia Lo-Carbon Tempra LP Single Room Heat Recovery Unit is available with a constant trickle speed and with a pullcord or switch to boost airflow. The units are suitable for installation into external walls up to 460mm thick and all installations can be carried out from inside a building. To facilitate ease of maintenance and installation the Tempra's simple construction is not difficult to fit in the same location as an existing 100mm diameter fan and offers easy access to the heat exchanger for regular maintenance. Under the Building Regulations Document F, continuous running products such as the Lo Carbon Tempra are only required to move an amount of air as laid down in table