Creative Home Travel Embroidery Manual Operation Simple Portable Mini Sewing Tools One size red

Please note: 1. SUITABLE FOR FABRICS BELOW 0.5MM, NOT SUITABLE FOR DENIM. 2. The use of this machine is more complicated, please refer to the instructions in the description. Material: Plastic, Metal Color: Red,White Size: One size Length and Height: 11 * 7cm Package included: 1 PC Instructions for use: 1. Holding the machine: use the four fingers of the right hand to support the base, and the thumb is naturally placed on the cover of the fuselage to hold the whole machine steadily. 2. Threading: Gently pull out the thread on the spool. Then pass through the lead coil. The threaded thread head is temporarily placed next to the needle, and the threader is passed through the pinhole from the front of the needle (to the fuselage joint), and then the thread head is introduced into the small hole of the threader, and the threader is exited and pulled out about 2-3 cm of the head wire and pressed to the plate. 3. Put the cloth: use the index finger of the right hand to lift the pressure plate, put the fabric ready for sewing (the thickness does not exceed 0.5 mm, not suitable for denim) flat under the pressure plate, and gently put the pressure plate back to press the fabric; 4. Sewing operation: hold the fabric with the left hand, gently and quickly press down the top of the cover with the thumb of the right hand to press to the end, and then press down with the thumb, and so on, the cloth feeding mechanism will automatically send the sewing object to the left. The right hand of the holding machine gradually moves to the right, and the left hand cloth gently moves the sewing object to the left with the sewing rhythm until the end of the sewing; Cut the thread end with scissors and gently pull up the pressure plate to remove the fabric. From the reverse side of the fabric to be sewn, pull out the back section of the thread, so that it is threaded into a coil next to it and tighten and tie a knot, and the stitches are firm; At the end of sewing, do not break the thread head by dead-pulling the fabric, so as not to damage the needle and stitch; 5. The machine can automatically feed the cloth and adjust the tightness between the pins, but pay attention to the following points: the pins are too tight, adjust the pressure nut slightly counterclockwise; The pins are too loose, adjust the pressure nut slightly clockwise; Tie the correct pin elastic. If you need a larger stitch, the left-hand pull can be slightly faster. If you need to have a tighter stitch, the left-hand pull can be slightly slower; 6. Wire changing group: If you change to a large wire group, you can connect the spare length rod with the wire drum shaft and sleeve into the large line group. Place the spare plastic cap at the end of the rod to fix the large thread mass, then re-thread it, adjust the tightness of the thread and sew it; Use cotton thread or synthesized thread effect. 7. Needle change: loosen the fixing screw and take out the broken needle. Install the new needle as shown,