X-sauce Presta Tubeless Kit

The Lightest Tubeless Kit! (with Plastic Bottom + Adhesive Tape) only 35 Grams Per Wheel (tapes + Valve)As the valve and the rim strip are independent, in case of an on road repair, it is not necessary to remove the tape, only take out the valve and put on the inner tube.- INCLUDES: 2 Presta valves or Schrader detachable tubeless compatible valves, 2 rim strips, adhesive tape, bottle of new ammonia-free sealant, injector for exact dose extraction, needle to inject, Schrader valve adaptor (in Presta valve kits) and instructions.For up to 3 cm high rims (if your rim is higher the valve cannot be tightened).Options:- For 26´´ Wheels With Presta Valve Or Schrader Valve And 20, 23, 25 And 27mm Rim Strip Width.- For 27,5´´ Wheels With Presta Valve Or Schrader Valve And 20, 23, 25 And 27mm Rim Strip Width.- For 29´´ Wheels With Presta Valve Or Schrader Valve And 20, 23 And 25 Mm Rim Strip Width.- Step 1: Instructions For The Election Of The Correct Rim BottomThe rim bottom should look like this:- To choose the width of the tire rim of the right kit for your tire you can do it by measuring the width of the tire from the outside.- To choose the width of the tire bottom of the right kit for your tire, it is best to disassemble your wheel, remove and measure the tire´s rim, provided it covers the bottom of the tire´s throat well. You must measure it on a flat surface, because if you do it on the rim itself, being concave, the data will not be correct. If your wheel does not have a rim bottom, cut a piece of paper of the width that you think fits and overlap it on the rim, adapting it to its concavity, so you will check whether it is correct or if you need a little more or less than a millimeter in width.- A second option is to measure the lower width of the rim, adding one or two millimeters to compensate for the concavity.Another option is to do it by measuring the width of the tire from outside and approximately:- For rims from 20 to 24 mm wide kit with rim bottom 20 mm wide- For rims from 25 to 28 mm wide kit with 23 mm wide rim bottom- For rims 29 to 35 mm wide kit with rim bottom 25 mm wide- For rims over 35 mm wide kit with rim bottom 27 mm wide- Step 2: Instructions For Assembling The Tubeless KitImportant Note:- We strongly recommend using Tubeless or Tubeless Ready tires for this kit to ensure ease of installation. With Tubeless tires a hand pump may be used for the final inflation step. - Inner tube type tires on the other hand, although most can also be used, require use of an air compressor for inflation and generally more mechanical ability because repeated inflations may be necessary immediately after introduction of X-SAUCE sealant in the tire to achieve correct sealing.Preparation of the rim: - Remove the rim strip or tape that might previously be on the rim a nd clean the rim thoroughly (photo 1). To do this you should use a rag with a household dissolvent (never alcohol, paint thinner, turpentine or other cleaners) and remove all