Victron Energy Skylla-i 24/100 Charger NT-705 (1+1)

A modern and powerful battery charger that withstands the rigors of an adverse environment:heat, humidity and salt air.- The right amount of charge for a lead-acid battery:variable absorption time.- BatterySafe mode:preventing damage due to excessive gassing.- Storage mode:less maintenance and aging when the battery is not in use.- Smaller and lighter compared to similar models.- NMEA 2000 Canbus connection.- PowerControl:set a maximum shore power.- Remote Control.- Li-ion (LiFePo4) ready.Features:Skylla-i (1+1):two outputs to charge 2 battery banks.The Skylla-i (1+1) features 2 isolated outputs.The second output, limited to approximately 4 A and with a slightly lower output voltage, is intended to top up a starter battery.Rugged.Aluminium epoxy powder coated cases with drip shield and stainless steel fixings withstand the rigors of an adverse environment:heat, humidity and salt air.Circuit boards are protected with an acrylic coating for maximum corrosion resistance.Temperature sensors ensure that power components will always operate within specified limits, if needed by automatic reduction of output current under extreme environmental conditions.Flexible.Next to a CAN bus (NMEA2000) interface, a rotary switch, DIP switches and potentiometers are available to adapt the charge algorithm to a particular battery and its conditions of use.Important features:Synchronised parallel operation Several chargers can be synchronised with the CAN bus interface.This is achieved by simply interconnecting the chargers with RJ45 UTP-cables.Please see the manual for details.The right amount of charge for a lead-acid battery:variable absorption time.When only shallow discharges occur the absorption time is kept short in order to prevent overcharging of the battery.After a deep discharge the absorption time is automatically increased to make sure that the battery is completely recharged.Preventing damage due to excessive gassing:the BatterySafe mode.If, in order to quickly charge a battery, a high charge current in combination with a high absorption voltage has been chosen, the Skylla-i will prevent damage due to excessive gassing by automatically limiting the rate of voltage increase once the gassing voltage has been reached.Less maintenance and aging when the battery is not in use:the Storage mode.The storage mode kicks in whenever the battery has not been subjected to discharge during 24 hours.In the storage mode float voltage is reduced to 2,2 V/cell (26,4 V for 24 V battery) to minimise gassing and corrosion of the positive plates.Once a week the voltage is raised back to the absorption level to 'refresh´ the battery.This feature prevents stratification of the electrolyte and sulphation, a major cause of early battery failure.To increase battery life:temperature compensation.Every Skylla-i comes with a battery temperature sensor.When connected, charge voltage will automatically decrease with increasing battery temperature.This feature is especially