Victron Energy Multiplus C 12/2000/80-30 Charger NT-606

The Victron MultiPlus compact brings toge ther a powerful sine wave inverter, a sophisticated battery charger with adaptive technology and a high-speed AC transfer switch in a single compact housing.Victron Multiplus Inverter Chargers are compatible with Lithium-Ion batteries.Features:Two AC outputs the main output has a no-break function the MultiPlus takes over the supply to the connected loads in the event of a blackout or mains/generator disconnection the second output is only active when one of the inputs of the MultiPlus is supplied with AC power.Devices that should not discharge the battery, such as a water heater, for example, can be connected to this output (second output only available on models with 50A transfer switch).Virtually unlimited power thanks to parallel operation .Up to 6 Multis can be operated in parallel to achieve higher power output and load.Three-phase operation capability in addition to parallel connection, three units of the same model can be configured for three-phase output.But that´s not all:up to 6 sets of three units can be connected in parallel.PowerControl - Limited power from generator, dock or mains the Multi is a very powerful battery charger therefore, it will use a lot of current from the generator or the pontoon grid (almost 10 A per 5kVA Multi at 230 VAC).A maximum current from the generator or pontoon can be set on the Multi Control Panel the MultiPlus will take the other AC loads into account and use the excess current for the load, thus avoiding overloading the generator or the pontoon network.PowerAssist - Boosting the electrical capacity of the pontoon or generator .This function takes the PowerControl principle to another dimension.It allows the MultiPlus to supplement the capacity of the alternative source.When a power peak is required for a short period of time, as is often the case, MultiPlus will immediately compensate for the possible lack of power from the pontoon or generator current with power from the battery.Variable four-stage charger and dual battery bank charging the main output provides a powerful charge to the battery system by means of advanced ´variable charging´ software the software fine-tunes the automatic three-stage process to match battery conditions and adds a fourth stage for extended periods of slow charging in addition to the above.The MultiPlus can charge a second battery.Setting up the system couldn´t be simpler .Once installed.The MultiPlus is ready to go.If the configuration needs to be changed, it can be done in a matter of minutes via a new DIP switch configuration procedure, or via the Victron software.