Victron Energy Orion-tr Smart 24/non-isolated Dc-dc Charger 24-17a 400w NT-1099

Each of the Orion-Tr Smart chargers can be monitored and programmed via Bluetooth and can be remotely controlled by remote on/off switch the Orion-Tr Smart charger can be used in 12 or 24 V systems and is suitable for both lead-acid and lithium batteries.Models up to 400 W are available and an unlimited number of units can be connected in parallel to increase power output.Designed to operate in high temperatures up to 55°C, with full rated power output up to 40°C.Features:Bluetooth Smart enabledBluetooth integrated.Any smartphone, tablet or other Bluetooth enabled device can be used to monitor, change settings and update the charger when new software features become available.Fully programmable.- Battery charging algorithm (configurable) or fixed output.- Intelligent alternator support:engine running detection mechanism.Adaptive 3-stage charging algorithm:initial charge - absorption - float.- In the case of lead-acid batteries, it is important that, if discharges are light.The absorption time is short to avoid overcharging the battery.After a deep discharge.The absorption charging time is automatically increased to ensure a complete recharge of the battery.- In the case of lithium batteries.The absorption time is fixed:2 hours by default.- Alternatively, a fixed output voltage can be chosen.Remote On/Off.A remote On/Off switch can be connected to a two-phase connector Alternatively.The H (right) terminal of the two-phase connector can be switched to battery positive, or the L (left) terminal of the two-phase connector can be switched to battery negative (or to the vehicle chassis, for example).All models are short-circuit proof and can be connected in parallel to increase the output current.An unlimited number of units can be connected in parallel.High temperature protection:the output current will be reduced when the ambient temperature is high.IP43 protection.If installed with screw terminals facing downwards.Screw terminals No special tools are required for installation.Screw terminals.No special tools required for installation input fuse (non-replaceable).