Chargers & Jump Starters

Composite case with moulded rubber protection, integral battery cable storage and carry handle. LED Battery condition, polarity check, with audible warning if polarity is reversed, and charge indicators. Features independent on/off switch which allows the positive clamp to be connected without the risk of sparking and an integral LED work light for use at night. Also features an integral air compressor with pressure gauge for accurately topping/pumping up tyres. Fitted with two 12V power sockets that will accept any 12V device fitted with a vehicle accessory socket plug. Also features a USB outlet (5V/1A). Supplied with mains charger.Specifications:Model No RS132Auxiliary Output: 2 x 12V Power …

A modern and powerful battery charger that withstands the rigors of an adverse environment:heat, humidity and salt air.- The right amount of charge for a lead-acid battery:variable absorption time.- BatterySafe mode:preventing damage due to excessive gassing.- Storage mode:less maintenance and aging when the battery is not in use.- Smaller and lighter compared to similar models.- NMEA 2000 Canbus connection.- PowerControl:set a maximum shore power.- Remote Control.- Li-ion (LiFePo4) ready.Features:Skylla-i (1+1):two outputs to charge 2 battery banks.The Skylla-i (1+1) features 2 isolated outputs.The second output, limited to approximately 4 A and with a slightly lower output voltage, is intended …

• Five pairs of coloured cables.• Each cable has shrouded crocodile clips at each end.• Use as extensions to multimeter leads, to bridge suspected open-circuit cables and as temporary wiring.Five pairs of coloured cables. Each cable has shrouded crocodile clips at each end. Use as extensions to multimeter leads, to bridge suspected open-circuit cables and as temporary wiring.• Five pairs of coloured cables. • Each cable has shrouded crocodile clips at each end. • Use as extensions to multimeter leads, to bridge suspected open-circuit cables and as temporary wiring. • Model No. VS222Technical Specification:Contents: Red, Black, Green, White, YellowNett Weight: 0.08kgDimensions: Length: 35mm x…

The new chargers of the SBC NRG + MINI series are even more efficient and compact thanks to new advances in technology. The redevelopment of the SBC NRG + charger allows 15% more output power than the industry standard, because it uses the injected current with almost no loss. They are used everywhere, where smaller power with small dimensions are needed. Thanks to the temperature-dependent ventilation system, the chargers not only quieter, but also protect your on-board battery at the same time.
3-stage charging curve IUoU
2 or 3 charging outputs for independent charging of several batteries by integrated charging current distributor (MosFet technology)
Each output is protected with integrated …

• Output: 12V 10A.• Battery Range: Max. 230Ah Lead Acid.• Fully automatic microprocessor controlled dual voltage battery charger and maintainer.• Patented Speed Charge technology actively monitors the charge acceptance and constantly modifies the charge output.• Charges the battery up to 3 times faster than conventional battery chargers without damaging the battery.• Heavy-duty sturdy case, no-nonsense controls, bright, clear, easy-to-read LED status lights and LED scrolling digital messaging display screen gives step-by-step instructions.• Charges conventional lead acid, calcium, AGM/GEL, leisure and stop/start batteries.• Fully automatic float mode ensures that the battery is kept fully ch…

Protects the battery against excessive discharge and can be used as a system on/off switchThe Smart BatteryProtect disconnects the battery from non-essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine. The on/off input can be used as a system on/off switch.
12/24 V auto rangingThe Smart BatteryProtect automatically detects system voltage one time only.
Bluetooth: programming made easyWhen using Bluetooth to program the Smart BatteryProtect any required engage/disengage levels can be set. Alternatively, one of nine predefined engage/disengage levels can be set with the programming pin (see manual). If …