Chargers & Jump Starters

Compact 6V/12V lead acid battery charger suitable for home and light workshop use. For use only with 6V/12V lead acid batteries rated between 9 and 112Ah. Features easy-to-read ammeter to indicate the level of battery charge. Also features overheating short and reverse polarity protection. Composite housing with carry handle. 1.8m Cable with insulated clamps.8A 6/12V Battery Charger 230V• Compact 6V/12V lead acid battery charger suitable for home and light workshop use.• For use only with 6V/12V lead acid batteries rated between 9 and 112Ah.• Features easy-to-read ammeter to indicate the level of battery charge.• Also features overheating short and reverse polarity protection.•

Victron Energy Blue Smart IP22 12-Volt 30 amp 230V with single Output is the new professional battery charger with wireless solution to monitor voltage and current, to change settings and to update the charger when new features become available The Blue Smart Charger features a microprocessor controlled adaptive battery management, The adaptive feature will automatically optimize the charging process relative to the way the battery is being used High efficiency and also Protected against overheating: With up to 94% efficiency, these chargers generate up to four times less heat when compared to the industry standard Also charges Li-ion batteries: Li-ion batteries are charged with a simple …

Electrify your tankbag (with a “crosshair” current input) or create a weather-proof power connection on your hardcase! Length: 10 inches (25 cm). DC 2.5 x 5.5 mm inner socket. -40°C/-40°F - Suitable for use at very low temperatures. Cable remains flexible at temperatures below freezing. Max. current rating: 5A. With line rubber seal for OptiMate heavy load SAE connection.

Easy to install Comes standard with an end cap attached to ensure the connection stays in good condition while not in use Convenient way to connect from a standard style O. E. , SAE or aftermarket pigtail lead to your CTEK products Easy to read display

Easy to use microprocessor controlled 12V battery charger. The mode selection control panel includes battery reconditioning (desulfation) the option to display volts/amps a charge button and the ability to select the charge rate: 1A 3A 5A and 10A. There is an LCD screen with easy to read icons. Rugged design fitted with on-board cord storage and clamp holder. There are also two USB ports for charging mobile devices.PTDDRPDIR53168

Switch between standard or BMW CAN bus program Ideal for: AGMMF, STD, GEL and spiral cell batteries from 2Ah to 50Ah Saving: 0.5V low voltage start 2stage desulfation recovery . Charging current: 1 A Accessories included: O9 DIN plug O4 clamp cable for charging on the bench

CPU controlled professional chargers with universal use for supply, charging, maintenance and reprogramming vehicles Voltage - 12V Amp - 10 - 120 Amp Power Watt - 1800 Charge - 10 - 1200Ah Maintenance - 10 - 3600Ah

ENGINEERED FOR SPEED: Delivers at least 40% faster charging than bosch standard 18v chargers with core18v 8 ah battery WORKS WITH HIGH-AMP BATTERIES: Fully charges a spent core18v 4 ah battery in 51 minutes 8-AMP CHARGING CURRENT: Delivers 4x the charging current compared to the gal18v-20 standard charger FAST CHARGER DESIGN: Gets users power ready faster with dual-mode charging COOLING FAN: Helps protect batteries from overheating while charging REGULATED DUAL-MODE CHARGE FOR CELL PROTECTION: Fast charge to 80%, remaining 20% is long-life mode FLEXIBLE CHARGING SOLUTION: Compatible with bosch 18v batteries and the ampshare system Bosch 18V chargers are covered by a five year limited …

The Batium microprocessor-controlled product range guarantees efficiency and safety. 6V and 12V 15Ah - 130Ah Ultra fast charging: 50% time saving compared to traditional chargers 100% charge: Batium allows a full charge of all types of battery: AGM gel, VRLA, liquid (Kurve IwUoU).

Car Battery Charger / Battery Charge

The Oximiser 900 is the ultimate optimiser that no garage should be without. Designed to be left permanently connected to provide guaranteed long-term battery care, the Oximiser 900 is suitable for most 12V battery types up to 30Ah including Gel, MF and Acid batteries. Even Heavily discharged batteries as low as 4.1V can be charged if the battery is not damaged. Do not use on Lithium batteries.6 Stage battery management system:Polarity Check: Checks the battery leads have been connected correctlyBattery Analysis: assesses battery & determines best charging methodBulk Fast Charge: Charges at a fast rate to bring the battery to approximately 85% capacityAbsorption Charge: lowers the charge rate …

BATTERY SUPPORT FOR ON THE GO: The D250SE is a fully automatic on-board charger that powers 12V lead-acid batteries with current up to 20A or secondary lithium-ion batteries with a capacity between 40 and 300Ah. The selectable charging algorithms are designed for 12 V AGM and lithium-ion batteries (*12 V LiFePO) Compatible with intelligent alternators: full functionality with all alternator types MAXIMIZED SOLAR ENERGY PERFORMANCE: The solar panel controller with maximum power point tracking (MPPT) optimises the available performance Charging of second and starter batteries: once the dual battery is fully charged, the D250SE automatically redirects maintenance charging power to the starter …

The GYSFLASH 4.12 (UK) is particularly recommended for recharging 12 V motorcycle, jet-ski, karting and light vehicle batteries. Charging capacity from 1.2 to 70 Ah (130 Ah in charge maintenance) Optimized for maintain a high level of performance in cold weather (“Cold charge” mode) Total protection: against short circuits, reverse polarity and overloads Compact, lightweight design and waterproof against dust and liquids (IP65) Fully automatic and intelligent charging curve in 7 stages (50% faster than a traditional charger) 230V Power supply Delivered with clamps and connection terminals

Jump Leads / Protection Short Circuit

Hogert Technik Battery charger This part corresponds to the original part in terms of performance. The quality of the spare part fully meets the requirements of the car manufacturers. Battery Charger: Please select your vehicle from the drop down list to check compatibility with the product.

Victron Energy Smart IP43 24-Volt 16 amp 85-250V (1+1) features 2 isolated outputs - The second output, limited to approximately 3 amp and with a slightly lower output voltage, is intended to top up a starter battery The Smart Charger features our well-known ‘adaptive’ battery management system that can be preset to suit different types of batteries. The ‘adaptive’ feature will automatically optimise the charge process relative to the way the battery is being used Bluetooth Smart enabled: Any Bluetooth enabled smart phone, tablet or other device can be used to monitor, to change settings and to update the charger when new software features become available Automatic voltage compensation: The char…