Chargers & Jump Starters Victron Energy

The Victron Energy Rubber Bumper can be used for the following range of Victron Energy Blue Smart IP65 Charger 12/10, 12/15, 24/8 Victron Energy Blue Smart IP65 Charger is already protected against dust, and water spray - now you can protect it from accidental damage too This rubber bumper protects your IP65 charger from knocks, bangs and scratches and helps extend its life Easy grip and shock absorbing construction Dimensions: 7.48 x 4.13 x 2.36 inches Weight: 0.31 lb This comes with 5 year Warranty Guarantee

Victron Energy Quattro 48-Volt 5000VA 70 amp is a combined 230V inverter and battery charger, additionally it can be connected to two independent AC sources In the event of grid failure, Victron Energy Quattro takes over the supply to the connected loads. This happens so fast that computers and other electronic equipment will continue to operate With the unique Power Assist feature Victron Energy Quattro will prevent overload of a limited AC source, such as a generator or shore power connection Up to 6 Victron Energy Quattros can operate in parallel to achieve virtually unlimited power, three phase or split phase operations are also possible Incorrect installation can be hazardous, Please …

Victron Energy Orion-Tr Smart 24/12-Volt 30 amp 360-Watt DC-DC Non-Isolated Charger is a professional DC to DC adaptive 3-stage charger with built-in Bluetooth and IP43 protection Can be used in 12-Volt or 24-Volt systems and is suitable for both lead acid and lithium batteries, unlimited multiple units can be connected in parallel to increase output power With Bluetooth Smart enabled the unit can be monitored and programmed via Bluetooth and can be remotely controlled via a remote on/off switch For use in dual battery systems in vehicles or on boats where the alternator and the start battery are used to charge the service battery Screw terminals: The screw terminals give the advantage of …

Bluetooth Smart enabled Fully programmable, Remote on-off All models are short circuit proof and can be paralleled to increase output current High temperature protected, IP43 protection Screw terminals, Input fuse (not replaceable)

Bluetooth Smart enabled Adaptive 3-stage charge algorithm: bulk ? absorption ? float Remote on-off IP43 protection High temperature protected

High efficiency, IP43 protection, Screw terminals Technical Specification: Input voltage range - 18-35V, Output voltage - 12.5V, Efficiency - 97%, Continuous output current - 10A, Max. Output current - 12A, Galvanic isolation - no, Operating temperature range (derate 3% per °C above 40°C) - -20 to +55°C, DC connection - Screw terminals Dimensions: Height - 73mm, Width - 94mm, Depth - 37mm, Weight - 0.2kg 5 Year Warranty

Victron Energy Mains Cord AUS/NZ Plug for Victron Energy Smart IP43 Chargers and Victron Energy Skylla-S Chargers Lemgth: 2 meter

The Cyrix-Li-Charge will connect a battery charger with 3 seconds delay The Cyrix-Li-Charge will disengage immediately whenever its control input becomes free floating, signalling cell over voltage or cell over temperature In general a cell over voltage alarm will reset shortly after charging has been stopped. The main feature is that there is virtually no voltage loss so that the output voltage of alternators or battery chargers does not need to be increased.

The Cyrix-Li-Charge will connect a battery charger with 3 seconds delay The Cyrix-Li-Charge will disengage immediately whenever its control input becomes free floating, signalling cell over voltage or cell over temperature In general a cell over voltage alarm will reset shortly after charging has been stopped. The main feature is that there is virtually no voltage loss so that the output voltage of alternators or battery chargers does not need to be increased.

Victron Energy Cyrix-Li-Charge will connect a battery charger with 3 seconds delay. Victron Energy Cyrix-Li-Charge will disengage immediately whenever its control input becomes free floating, signalling cell over voltage or cell over temperature In general, a cell over voltage alarm will reset shortly after charging has been stopped. Victron Energy Cyrix will then reconnect the charger after a delay 3 seconds When Victron Energy Cyrix-Li-Charge is engaged (charger connected to battery) it will disengage after 1 hour to check if the charger is still enabled If, after the Victron Energy Cyrix has disengaged, the output of the battery charger immediately increases to 13 V or more, Victron Energy …

The Victron Energy Clamp Connector (with 30 amp ATO fuse) for Victron Energy Blue Smart IP65 charger This accessory is for Blue Smart IP65 Charger + DC connector only This Clamp Connector's 30 ATO fuse provides safety Dimensions: 0.55 x 0.47 x 0.12 inches Weight: 0.26 lb This comes with 5 year Warranty Guarantee

Automatic Three Stage Charge Characteristic, Auto-Ranging Input, Maintain Full Output Power Within the Entire Specified Range Technical Specification: 24V, Leisure, 45-65Hz 5 Year Warranty

Automatic Three Stage Charge Characteristic, Auto-Ranging Input, Maintain Full Output Power Within the Entire Specified Range Technical Specification: 12V, Leisure, 45-65Hz 5 Year Warranty

Automatic Three Stage Charge Characterisitc, Maintain Full Power Within the Entire Specified Range Technical Specification: 12V, Leisure, 45-65Hz 5 Year Warranty

Liquid crystal display, Load output, Day/night timing of the load output, Programmable battery charge algorithm, Two 5 Volt USB outputs | 2 Year Warranty Specification: Battery Voltage - 48V, Rated charge current - 30A, Automatic load disconnect - Yes, Maximum solar voltage - 100V, Operating temp. range - -35 to +60°C (full load), Humidity (non-condensing) - Max 95%, Protection class - IP20 Battery: Charge voltage 'absorption' - Factory setting: 57,6V, Charge voltage 'float' - Factory setting: 54,8V, Low voltage load disconnect - Factory setting: 44.8V, Low voltage load reconnect - Factory setting: 50,4V USB: Voltage - 5V, Current - 2A (total from 2 outputs) Dimensions: Height - 101mm, W…

Liquid crystal display, Load output, Day/night timing of the load output, Two 5 Volt USB outputs | 2 Year Warranty Specification: Battery Voltage - 48V, Rated charge current - 20A, Automatic load disconnect - Yes, Maximum solar voltage - 100V, Operating temp. range - -35 to +60°C (full load), Humidity (non-condensing) - Max 95%, Protection class - IP20 Battery: Charge voltage 'absorption' - Factory setting: 57,6V, Charge voltage 'float' - Factory setting: 54,8V, Low voltage load disconnect - Factory setting: 44.8V, Low voltage load reconnect - Factory setting: 50,4V USB: Voltage - 5V, Current - 2A (total from 2 outputs) Dimensions: Height - 101mm, Width - 184mm, Depth - 47mm, Weight - 0.3…

Ultra-fast Maximum Power Point Tracking (MPPT) - Load output Battery Life: intelligent battery management - Programmable battery charge algorithm Day/night timing and light dimming option - Programming, real-time data and history display options Dimensions: 100H x 113W x 40D (mm) - Weight: 0.5 (kg) - Warranty: 5 Years