Effects Pedals

Compact 7-band graphic equalizer pedal with wide frequency range from 50 Hz to 10 kHz for electric bass guitar that provides total shaping control over the tone and eliminates feedback. 7 frequency bands (50, 120, 400, 500, 800 Hz; 4.5, 10 kHz) with a 15 dB of Boost/Cut provide extensive tone-shaping options, while first-class electronic on/off switch ensures noise-free operation. Pedal also features status LED for effect on/off and battery check. It can be powered by 9 V battery or 9 V adapter PSU (not included). Dimensions: 70 x 54 x 123 mm. Weight: 330 g.
UK/EU Power supply included: No
Battery Detail: Al/Mn
Type: Equalizer
Power Supply: Adapter
Battery Operation: Yes
Made in: China…

Stereo chorus guitar effect pedal that features dedicated Level, Tone, Rate and Depth controls for an incredible sound shaping. It also provides a status LED indicator for effect on/off and battery check, and a first-class electronic on/off switch that maintains incredible signal integrity in bypass mode. Pedal can be powered by either a 9 V battery or DC power supply (not included). Dimensions: 54 x 70 x 122 mm. Weight: ca 330 g.
Type: Chorus
Made in: China
Battery Operation: Yes
Power Supply: Adapter
UK/EU Power supply included: No

The Strymon 9V UK Power Supply can be used to power your Strymon effects pedal and any other 9V centre negative pedals. Offering up to 667mA the Power supply will make sure your pedal is running at maximum allowing you to use your pedal to the best of its ability. Its low noise operation and automatic worldwide voltage conversation Strymons official power supply is perfect as a replacement to keep your pedal going no matter where.

The Behringer TO800 Vintage Tube Overdrive pedal is a faithful recreation of that classic green overdrive. The inclusion of the defining 4558 op-amp chip is a nice nod to the original design along with the familiar 3-knob layout which both looks sleek and is remarkably easy to use. With these controls you can adjust the level of the effect adjust the tone and set how much gain youd prefer. This allows you to sculpt your tone however you see fit from a light boost to thick resonant overdrive. Whatever crunchy tone youre after the TO800 will deliver.

Robust 7-band EQ pedal for electric and electric-acoustic guitar that shapes the sound and eliminates unwanted feedback. Pedal offers a wide frequency range – from 100 Hz to 6.4 kHz, with a powerful 15 dB boost or cut of each EQ band. It is equipped with a first-class electronic on/off switch for highest signal integrity n bypass mode, and status LED for on/off and battery check. Powered by 9 V battery or the BEHRINGER PSU-SB DC power supply (not included). Dimensions: 54 x 70 x 123 mm. Weight: 330 g.
Type: Equalizer
Power Supply: Adapter
Battery Operation: Yes
Made in: China
UK/EU Power supply included: No

The Strymon Zuma Mounting Kit is the perfect solution for affixing your power supply in a discreet manner. It keeps your Zuma high current PSU stored underneath your PedalTrain board leaving more space for creative pedals up top! Please note: The Zuma Mounting Kit is not compatible with older model Pedaltrain boards (PT-1 PT-2 PT-JR) with holes on the rear brace instead of an open pass through for the length of the board. For those boards we recommend affixing Zuma to your board with Dual-Lock®.

Power Suply: Input: 100-240V ~ 50-60Hz / Output: 9V, 1.3APolarity: Center NegativeCompatible with DigiTech Whammy Pedal I, Whammy Pedal II, Whammy 4, Whammy 5, VHM5, MV5, GNX 1, VX 400, Vocalist Workstation, Vocalist Access, Vocalist VR, Vocalist Live 2, Vocalist Live 4, RP 3, S100, S400, RP 100 / 150 / 200 / 250 / 300 / 350, 500, RPx 400, Vocal 300, BP 200, Genesis 1, Jam Man Looper, Jam Man SoloXT Looper, Jam, Man Express XT Looper, Jam Man Stereo Looper, iStomp – 2,1 x 5,5 mm Barrel connector, negative center.
Made in: China
Voltage: 9V
Current (mA): 1300.0
Plug Type: Barrel
Polarity: Center Minus
Type: Power Supply

The Behringer UO300 Ultra Octaver Pedal gives you that extra cutting edge to your sound by adding up to two additional tones to your guitar. Offering notes that are either one to two octaves lower than the original sound packing in that extra punch. You can also adjust all three tones at any moment with intuitive and individual volume controls for each one which accompanies a switch that offers brilliant bass performance. With a performer friendly LED status light you can tell if the pedal is active wherever you are on stage.

Durable single piano-style footswitch pedal with natural feeling that is compatible with Yamaha, Roland, Kawai and Akai products. Its metal body is covered with thick black urethane bumper, and the long-frame design large rubberized footprint and substantial weight prevents sliding on most surfaces. 1.8 m long cable with 6.3 mm mono phone plug is included. Black and white colour combination.
Original Colour by Producer: Black;Black
Made in: China
Colour: Black
Compatible with: Roland;Yamaha;Kawai;Akai
Polarity Switch: No
Type-A Connector: Jack MONO 6,3 mm Male
Type: Sustain Pedal

D’Addario XPND Pedal Risers are designed to elevate pedals in those “tough to stomp” places. Mont the risers using the included hook and loop strips and raise any pedal a full inch, making it easy to access. You can align multiple risers across your board as needed, and with built-in-cut-outs for simple cable routing, adding risers is quick and hassle-free. XPND Pedal Risers are built to last and are available in single or double width, to accommodate dual-sized or multiple pedals.
Made in: Vietnam
Material: Aluminium
Variant: Large
Size: L
Colour: Black

A distortion effect pedal. It has dense, tube-like distortion sound with an endless sustain. Its ideal for extreme hard rock or heavy metal sounds. The sound is adjusted using Distortion, Level potentiometers and a 3-band equalizer. In addition, it is equipped with a blue status LED, foot switch and ¼'' In/Out connectors. The effect is powered by a 9 V battery or adapter (not included).
Type: Overdrive;Distortion
Battery Operation: Yes
Made in: China
UK/EU Power supply included: No

Setting up amps, dialing in tones and positioning mics takes a lot of time and patience. Step on the amazing TUBE AMP MODELER TM300 and skip straight to the good part! The TM300 features authentic modeling technology for 3 classic guitar amps, 3 gain modes and 3 mic placements for a total of 27 configurations that let you easily achieve the most sought-after tube amp sounds – from clean to crunch to super-fat distortion.
Type: Tube Amp Modeler;Distortion;Equalizer
UK/EU Power supply included: No
Made in: China
Battery Operation: Yes
Power Supply: Adapter

The power supply 1 SPOT you can use anywhere in the world without a voltage converter because it automatically converts voltage worldwide. No need to worry about AC hum interfering with your sound either. the 1 SPOT is one of the quietest power sources. It is the 9V DC adapter that only takes up one spot on your power strip. With the ability to handle up to 1700mA, the 1 SPOT can power your entire pedalboard.
Power Supply: 9V;Adapter
Current: 1700 mA
Plug Type: Barrel
Colour: Black
Polarity: Center Minus
Voltage: 9V
Connector Angle: Straight
Type: Adapter
Made in: China
Variant: 1 SPOT
Current (mA): 1700.0
ChargerType: Power Supply…

The Behringer CS400 Compression and Sustain Ultimate Dynamics effects pedal is the perfect option for balancing your level. Ensuring that your quieter strikes ring with resonance while simultaneously reducing harsh loud tones. With intuitive controls for Level Tone Attack and Sustain you can fully personalise this stompbox tone to maximise its full potential. Utilising an active status LED you will always be able to tell when this pedal is enhancing your dynamics.

A standard in pedal switches, with a medal body for durability. Use as a damper switch or as a control switch for functions such as start/stop. Attached cable.
Made in: Japan

Approved 12V DC/1000mA power supply with negative centre that is compatible with TC Electronic stompbox pedals.
UK/EU Power supply included: No
Power Supply: 240V
Current (mA): 1000.0
Made in: China
Number of Outputs: 1
Current: 701-1000 mA
Voltage: 12V
Plug Type: Barrel
Polarity: Center Minus
ChargerType: Power Supply

Passive Cabinet Merger. The concept behind Palmer's Cab Merger may be very simple, but the unit fills an important gap! Have you ever wanted to connect two guitar cabinets to just one amplifier output? It's quite simple with the PCABM! In addition, you can choose parallel or series wiring. For instance, two 8 ohm cabinets can be connected for a total load of 4 ohms (parallel) or 16 ohms (in series). The device is entirely passive and does not affect tone in any way. Dimensions: 105 x 35 x 35 mm, weight: 0,13 kg
Made in: Germany
Type: DI Box
UK/EU Power supply included: No

Stylish, lightweight, and durable, the CB-GT1 bag is the perfect solution for transporting the GT-1 Guitar Effects Processor and essential accessories. The rugged exterior and thick internal padding shield your gear from bumps and bruises, while a convenient shoulder strap and reinforced handle make carrying easy.
Made in: Vietnam
Waterproof: Yes
Strap: Shoulder Strap;Yes
Type: Pedal Bag
Padding: Yes
Colour: Black
Original Colour by Producer: Black;Black
Handle: Yes

Custom moulded in the UK to fit the contours of the Headrush Mx5. Super durable polycarbonate shell offers a high level of protection and slides straight into equipment bags, making it ideal for the travelling. Shields faders and controls from dust, liquid and accidental impact whilst accommodating cables. At home, on the road or in the club, Decksaver has your Headrush Mx5.
Compatible with: Headrush Mx5
Made in: United Kingdom
Type: Dust Cover

Custom moulded in the UK to fit the contours of the Strymon Nightsky & Volante. Super durable polycarbonate shell offers a high level of protection and slides straight into equipment bags, making it ideal for the travelling. Shields faders and controls from dust, liquid and accidental impact whilst accommodating cables. At home, on the road or in the club, Decksaver has your Strymon Nightsky & Volante.
Type: Dust Cover
Made in: United Kingdom
Compatible with: Strymon Nightsky / Volante

Compact and portable 3-button footswitch pedal for use with several DigiTech products, including The Jimi Hendrix Experience, The JamMan, or Expression Factory. Pedal provides increased functionality and convenient Hands-free control over up/down selection of Models, Mode changes, Loop selection, automatic Start/Stops, and auto record where applicable. It is equipped with durable metal chassis construction, one 1/4" input and 3 m stereo TRS cable.
Colour: Black
Power Supply: Passive
Number of Buttons: 3
Battery Operation: No
Type: Footswitch

The Behringer TU300 Chromatic Tuner is a necessity for any modern performer. Keeping your instrument at the correct tuning is essential to any performer and this makes that job a whole lot easier. Featuring a seven-segment LED indicator you can select between seven different tuning modes and an eleven-point stream meter can ensure the utmost precision at any moment. Whether you are on stage or in the studio this is the perfect companion for you.

The TC Helicon Singles Connect Kit is a cable set for connecting up to four vocal effects pedals together. With minimal cable clutter and simple usage the Singles Connect Kit is an essential audio and power accessory kit for the VoiceTone Single pedals. Including a 12V/1A power supply DC interconnect/daisy-chaining cables and three short XLR cables the Singles Connect Kit opens up a wide range of options for connecting your effects.

Bass Preamp / Pedal