Power Saws

Crafted with precision engineering and cutting-edge technology, the TSC 55 delivers exceptional cutting results in a variety of materials, from hardwoods to composite materials. Its plunge-cutting capability allows for clean and accurate cuts, making it ideal for a wide range of applications. The TSC 55 boasts an ergonomic design and intuitive controls, providing comfortable handling and precise control during operation. Equipped with two powerful 5ah batteries, this saw provides long-lasting performance, allowing you to work uninterrupted for extended periods. Features & Benefits • Concentrated torque and up to twice as fast work progress with an increased saw blade service life • …

Designed to provide a high performance, similar to a 30ml class engine Pole Saw
300mm bar length, pitch 3/8” and 0.050” chain gauge, saw chain type 91PX-46
160ml oil tank capacity
Captive nuts
Telescopic pole with tool-less pole adjustable from approximately 2.6 metres up to 3.8 metres
Active Feedback Sensing Technology (AFT)
eXtreme Protection Technology (XPT)
Battery protection circuit
Ideal for pruning and limbing in tall trees or hard to reach areas…
Not compatible with G-Series batteries

The DeWalt DCS520 FlexVolt XR Plunge Saw has a brushless, heavy-duty motor which offers the same power as a mains tool and makes it perfect for plunging into a wide variety of materials whilst offering consistent speed and an accurate cut under heavy loads. It features an anti-kickback system which allows the user to go about cutting tasks without fear of injury or damage to the workpiece. It will also achieve 90% dust extraction when fitted to an extractor thanks to the closed guard, making it a perfect choice for mobile plunge cutting on site. Specifications • No Load Speed: 2,500-4,200rpm • Blade Diameter: 165mm • Blade Bore: 20mm • Bevel Capacity: 47° • Max. …

Easy to use
Good product for use
Good performance
Good quality

The cast iron table tilts from 90 degrees to 45 degrees, on a rack & pinion, and has a positive stop at both of those positions. Any angle in between can be read off the scale and locked in. For rip cuts the guide fence can be situated on either side of the blade, can be locked into position with a single press of the lever and has a clear marker to set against the metric scale. The fence itself can be fitted in two ways. When cutting thicker material the full face height of 60mm is used. When cutting thin and narrow strips the fence is fitted with the small face, against the blade to allow clearance around the guides. The bandsaw is fitted with an LED work light on a flexible stem, so that …