Soldering Tools Powertec

This handy little object is used to hold squigley wire in place while welding, avoiding painful burnt fingers and ensuring a better quality weld.

Great for use on boron and ultra high strength steels, the SpotMatic Spot Weld drill kit is consistent from the first spot weld to the last. With 1000rpm operating speed and 6.3 bar operating pressure, this is a capable and reliable tool. Featuring an innovative g frame, allowing for easy spot removal along an edge.

For use during MIG welding, these plug weld pliers from Power-Tec provide the user with even better weld penetration and don't allow burning through even thin panels when welding. They clamp and support the weld area for greater accuracy, safety and finish.

'L' welding clamp, manufactured for use in hard to reach areas. With 0-18mm adjustment.

A handy and easy to use tool, designed to create 13mm deep, 20 gauge steps or flange in sheet metal, or 7mm holes if required. Ideal for panel replacement, patching and for plug welding preparation.

Easy to use, but very effective, these door skinning pliers are used to prevent damage to panels while crimping them, saving time and money.

Designed for use in areas that are usually hard to reach, this 7mm hole punch is ideal for use on wing or channel sections of bodywork, or anywhere where a lip or other obstruction may stop you from hole punching with a regular sized punch.

Used extensively in car body restoration work on curved panels. Creates a 20mm deep step or flange onto a curved panel for flush lap weld joints.

Ideal when welding patch repairs in floors, wings, door skins, or when assembling fabricated panels on reskinning projects. The intergrips will clamp flat, curved or even pressed ribbed panels and are designed to leave only a small gap which will allow full penetration of the weld. Once the two sections are tack welded together, the wing nut is slackened, the toggle bar removed and the clamp lifted from the job prior to the final welding.

Ideal tool set for welding around boot and window edges, door columns etc.

This simple to use temperature measuring pen works at 121ºC and can be used on a wide range of surfaces. Simply swipe the temperature stick across the surface and when it melts, you get an instant, accurate indication that the rated temperature is achieved. It's as simple as that. Specially engineered for accurate temperature indication in pre-heating, interpass and post-weld heat treating applications.