Chargers & Jump Starters

• Cable & Clamp Length: 0.72m.• Composite hi-vis green case with moulded rubber protection, integral battery cable storage and carry handle.• LED Battery condition, polarity check, with audible warning if polarity is reversed, and charge indicators. • Features independent on/off switch which allows the positive clamp to be connected without the risk of sparking and an integral LED work light for use at night.• Fitted with two 12V power sockets that will accept any 12V device fitted with a vehicle accessory socket plug.• Also features a USB outlet (5V/1A).Composite hi-vis green case with moulded rubber protection, integral battery cable storage and carry handle. LED Battery condition, polarity ch…

Protects the battery against excessive discharge and can be used as a system on/off switchThe Smart BatteryProtect disconnects the battery from non-essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine. The on/off input can be used as a system on/off switch.
12/24 V auto rangingThe Smart BatteryProtect automatically detects system voltage one time only.
Bluetooth: programming made easyWhen using Bluetooth to program the Smart BatteryProtect any required engage/disengage levels can be set. Alternatively, one of nine predefined engage/disengage levels can be set with the programming pin (see manual). If …

Extension for 5.A charger cable with splash and dirt proof SAE connection system.Length.4.6.m.Industry standard two-pin SAE connectors.Max rating of the cable:5.A.20.?C./.4.?F, use in low temperatures.Includes in-line rubber seal for the OptiMATE heavy-duty SAE connector.

A modern and powerful battery charger that withstands the rigors of an adverse environment:heat, humidity and salt air.- The right amount of charge for a lead-acid battery:variable absorption time.- BatterySafe mode:preventing damage due to excessive gassing.- Storage mode:less maintenance and aging when the battery is not in use.- Smaller and lighter compared to similar models.- NMEA 2000 Canbus connection.- PowerControl:set a maximum shore power.- Remote Control.- Li-ion (LiFePo4) ready.Features:Skylla-i (1+1):two outputs to charge 2 battery banks.The Skylla-i (1+1) features 2 isolated outputs.The second output, limited to approximately 4 A and with a slightly lower output voltage, is intended …

• Compact 6/12V dual bank battery charger perfect for automotive, motorcycle and marine workshops.• Suitable for charging a variety of batteries, charger reacts continuously to battery condition and delivers whatever charge rate is required.• Two bank charger outputting 2 x 5A depending on the condition and charge of each battery.• Constantly regulated voltage patterns allow the battery to be recharged fully and safely without fear of overcharging.• Compatible with all AGM, Gel and VRLA flooded batteries commonly found in everything from automotive and farm equipment to motorcycles, ATVs, golf buggies and lawnmowers.• Supplied with SAE “quick” connectors on leads and battery terminals eyelet…

Charger DC / DC-TR Smart Victron Orion 24 / 24-17 (400W) with Bluetooth integrated galvanic isolation.Load two banks of dissimilar batteries.Features:Bluetooth Smart enabledBluetooth integrated.Any smartphone, tablet or other Bluetooth enabled device can be used to monitor, change settings and update the charger when new software features become available.Fully programmable.- Battery charging algorithm (configurable) or fixed output.- Intelligent alternator support:engine running detection mechanism.Adaptive 3-stage charging algorithm:initial charge - absorption - float.- In the case of lead-acid batteries, it is important that, if discharges are light.The absorption time is short to avoid overcharging …