Amplifiers

Phantom power adapter that runs on AA batteries and provides powering for electret condenser microphones when phantom power is not available. It features an on/off switch and a bass roll-off filter. Connectors are standard XLR-m to mini XLR-m. It can be used with various Audix microphones, including the ADX20iP, ADX40, ADX60, f90, MicroD, or MicroHP models.
Made in: China

Standard active DI box. Can be operated with 9 V batteries or 48 V phantom power. High-impedance input; higher output level than with a passive DI box. Active circuitry allows for high input impedance ( 1 meg. ohm) and higher input sensitivity (typical difference between in and out -4 dB). Maximum output impedance with phantom power operation +10 dB. Output: transformer balanced. The special "floating ground" circuitry enables ground lift even during phantom power operation. Metal case 110 x 73 x 42 mm. Weight: 0,36 kg
Power Supply: 48V Phantom
UK/EU Power supply included: No
Made in: Germany
Type: DI Box
Battery Operation: Yes

PPA-4 Stereo Headphone Amplifier For 4 Pairs Of Headphones Stereo Headphone Amplifier 4 separate headphone amplifiers, each with 1 level control Technical Specification Input 300mV Output 2 x 16mWRMS/8Ω 2 x 35mWRMS/32Ω 2 x 15mWRMS/600Ω (per headphone) Frequency range 20-20,000Hz S/N ratio 64dB THD 0.1% Admiss. ambient temp. 0-40 �C Power supply via suppl. plug-in PSU Dimensions 117x93x40mm Weight 375g Line input, stereo 1 x 6.3mm jack Headphone output, stereo 4 x 6.3mm jack

The TritonAudio FetHead Filter Microphone Preamp with High-Pass Filter is the perfect pairing with ribbon and low-output dynamic microphones. Although it may be small it is mighty. When connected to your microphone it delivers a clean boost of up to 27dB. This means you no longer need to crank your preamp to achieve the perfect level of gain. Theyll be no more noise or hiss just great sounding recordings! The FetHead features a integrated high pass filter at 220Hz. This is perfect for minimising proximity effect which can often occur with figure-eight polar patterns or when a microphone is placed closed to a source. Thanks to the gentle 6dB slope the filter will be subtle allowing the Fethead …

The Palmer ABO is a balanced switch with one input and two outputs which allows you to route a signal to one of two different outputs.

Adastra WA-215 2.0 channels Home White

Mini Amplifier / Stereo / Output power per channel 50 Watt / 3.5mm-In / Bluetooth

The TritonAudio FetHead In-Line Preamp is the perfect pairing with your condenser microphone. Although it may be small it is mighty. When connected to your microphone it delivers a clean boost of up to 18dB. This means you no longer need to crank your preamp to achieve the perfect level of gain. Theyll be no more noise or hiss just great sounding recordings! Incredibly easy to install simply connect the FetHead in between your XLR equipped microphone and cable. All the components are housed within a rugged durable chassis that is perfect for protection from superficial damage guaranteeing a long-lasting life. Whether youre on-stage or in the studio rest assured knowing youll sound great thanks …

Whenever you need more headroom for any microphone in your podcast, recording studio or stage setup, the MIC BOOSTER CM-2 is exactly the tool you need to get a crisp and clean microphone signal in a robust and simple to use package. Both channels of the CM-2 can work with almost any dynamic or passive ribbon microphone. Its high-quality preamp adds an incredible +25dB of gain to your mic pre’s which increases headroom and allows you to dial in the perfect mic level at a much lower gain setting at the mixer thus leading to a cleaner sound. The simplicity and size of the CM-2 means you can set it up as close as possible to any mic anywhere in your studio or on stage. This minimizes the risk …

The BOSS BAS-1 Amplifier Stand cradles your favorite combo guitar amp at the perfect angle for monitoring and sound projection, whether at home, on stage, or in the studio. Constructed with heavy-duty steel for long-lasting durability, the BAS-1 features an adjustable tilt-back design and a telescoping support arm that accommodates a variety of cabinet widths. The stand collapses for easy travel, with a locking cam and quick-release lever for fast set up and tear down. And with adjustable feet, you can achieve wobble-free stability when using the BAS-1 on slightly uneven surfaces.
Made in: China
Depth (cm): 44.5
Weight: 4,1 kg
Width (cm): 69.4
Load Capacity: 21 kg
Maximum Height: 520 mm
Height …

Apart BUZZSTOPIII
Universal Stereo Input Adapter

The Apart BUZZSTOP-MKIII is a universal input adaptor that can be used for all connections and extensions. The input level selector allows you to convert any amplifier output to any line-level output balanced or unbalanced. (E.g.: You can convert a 100V loudspeaker signal into a balanced or unbalanced line level signal). The BUZZSTOP-MKIII also makes it possible to convert an unbalanced signal into balanced and vice versa.

A 19” adaptor set is available. This way it is possible to mount 2 BUZZSTOP-MKIII in a 19” rack. (REF: BUZZ-19)

Often the BUZZSTOP-MKIII is used to solve humm and buzz problems via the build-in audio transformer.…

Dual reamping direct box. The DUALXDirect provides two independent high quality active interfaces that let you connect instrument, line, or speaker level signals to a mixer or other balanced inputs. Each of the high impedance 6,35 mm and XLR inputs are buffered and converted by very low noise active electronics into an isolated, balanced, low impedance signal output. The DUALXDirect has an extremely flat and wide frequency response and can handle high signal levels. This gives the DUALXDirect a very clean and neutral sound with a wide variety of signal sources and over long signal runs in high noise environments. Frequency response: 10 Hz - 100 kHz. Dimensions: 47 x 117 x 99 mm. Weight: 0,38 …