Amplifiers

Whenever you need more headroom for any microphone in your podcast, recording studio or stage setup, the MIC BOOSTER CM-2 is exactly the tool you need to get a crisp and clean microphone signal in a robust and simple to use package. Both channels of the CM-2 can work with almost any dynamic or passive ribbon microphone. Its high-quality preamp adds an incredible +25dB of gain to your mic pre’s which increases headroom and allows you to dial in the perfect mic level at a much lower gain setting at the mixer thus leading to a cleaner sound. The simplicity and size of the CM-2 means you can set it up as close as possible to any mic anywhere in your studio or on stage. This minimizes the risk …

The TritonAudio FetHead In-Line Preamp is the perfect pairing with your condenser microphone. Although it may be small it is mighty. When connected to your microphone it delivers a clean boost of up to 18dB. This means you no longer need to crank your preamp to achieve the perfect level of gain. Theyll be no more noise or hiss just great sounding recordings! Incredibly easy to install simply connect the FetHead in between your XLR equipped microphone and cable. All the components are housed within a rugged durable chassis that is perfect for protection from superficial damage guaranteeing a long-lasting life. Whether youre on-stage or in the studio rest assured knowing youll sound great thanks …

Mini Amplifier / Stereo / Output power per channel 50 Watt / 3.5mm-In / Bluetooth

Adastra WA-215 2.0 channels Home White

The Palmer ABO is a balanced switch with one input and two outputs which allows you to route a signal to one of two different outputs.

PPA-4 Stereo Headphone Amplifier For 4 Pairs Of Headphones Stereo Headphone Amplifier 4 separate headphone amplifiers, each with 1 level control Technical Specification Input 300mV Output 2 x 16mWRMS/8Ω 2 x 35mWRMS/32Ω 2 x 15mWRMS/600Ω (per headphone) Frequency range 20-20,000Hz S/N ratio 64dB THD 0.1% Admiss. ambient temp. 0-40 �C Power supply via suppl. plug-in PSU Dimensions 117x93x40mm Weight 375g Line input, stereo 1 x 6.3mm jack Headphone output, stereo 4 x 6.3mm jack

Standard active DI box. Can be operated with 9 V batteries or 48 V phantom power. High-impedance input; higher output level than with a passive DI box. Active circuitry allows for high input impedance ( 1 meg. ohm) and higher input sensitivity (typical difference between in and out -4 dB). Maximum output impedance with phantom power operation +10 dB. Output: transformer balanced. The special "floating ground" circuitry enables ground lift even during phantom power operation. Metal case 110 x 73 x 42 mm. Weight: 0,36 kg
Power Supply: 48V Phantom
UK/EU Power supply included: No
Made in: Germany
Type: DI Box
Battery Operation: Yes

The TritonAudio FetHead Filter Microphone Preamp with High-Pass Filter is the perfect pairing with ribbon and low-output dynamic microphones. Although it may be small it is mighty. When connected to your microphone it delivers a clean boost of up to 27dB. This means you no longer need to crank your preamp to achieve the perfect level of gain. Theyll be no more noise or hiss just great sounding recordings! The FetHead features a integrated high pass filter at 220Hz. This is perfect for minimising proximity effect which can often occur with figure-eight polar patterns or when a microphone is placed closed to a source. Thanks to the gentle 6dB slope the filter will be subtle allowing the Fethead …

Phantom power adapter that runs on AA batteries and provides powering for electret condenser microphones when phantom power is not available. It features an on/off switch and a bass roll-off filter. Connectors are standard XLR-m to mini XLR-m. It can be used with various Audix microphones, including the ADX20iP, ADX40, ADX60, f90, MicroD, or MicroHP models.
Made in: China

From acoustic guitars to laptops, always sound your best with MDB Series Direct Boxes. Available in four different models, the MDB Series will give you the peace of mind that your sound will faithfully get to your audience the way that you hear it on stage. Direct boxes are an essential tool for any stage or studio. They make it easy to get clean, low-noise audio to a mixer no matter what instrument you are using. Available in four versatile models, our ultra-affordable DI's offer the Mackie sound quality that you expect with Built-Like-A-Tank™ construction for maximum reliability. From acoustic guitars to laptops, be ready for anything with MDB Series direct boxes. With four models to choose fr…

48 V phantom power supply for electret microphones and microphone cartridges. Conectors: XLR input (bal.)/XLR output (bal.), Input voltage: via encl. plug-in power supply, Output voltage: +48 V, Admiss. ambient temp.: 0-40 °C, Dimensions: 126 x 75 x 45 mm, Weight: 535 g
Made in: China