Effects Pedals

The 9V Compact Power Supply by Gear4music (Multi Plug) is built for guitarists in the UK and EU needing a dependable way to power their effects pedals. The 9V centre-negative PSU ensures clean consistent power across your board. The 2A output gives you plenty of headroom to run a pedal without noise or voltage drop. Thanks to its switch mode design this PSU stays lightweight and efficient making it easy to carry and suitable for both stage and studio use. With a 4.5mm connector and 1.8m of cable its ready to handle a wide range of situations with ease. Please check compatibility with your device before purchasing. See a detailed specification list below.

The Palmer PW9V is a standard 9 volt power supply which can be used to power a range of electric guitar and bass effects pedals. With a maximum power consumption of 500 mA and lengthy cable of 1.50 metres the PW9V is the perfect addition to your set up as it allows you to save money on 9 volt batteries.

The Palmer Hook and Loop Fastener is a 1 metre strip of self-adhesive tape which is perfect for mounting devices on pedal boards.

The Electro Harmonix 9LDC-500 Power Supply grants you an easy tidy setup. Delivering 9 volts DC this power supply is suitable for the 2880 HOG Holiest Grail and 16-Second Delay pedals and will ensure theyre given the ultimate fuel they need to perform at their best. Play without the burden of electrical noise tainting your set use time and again thanks to immense durability and equip yourself with the kind of quality that only Electro Harmonix can provide. Whats more the 9LDC-500 also offers brilliant heat reduction and voltage damage protection meaning you can rely on it to deliver every time.

The Behringer PSU-HSB-ALL Power Adapter is designed for use with a wide variety of 9-volt devices including over 20 effects pedals at a time and keyboards. The adapter is supplied with 4 x assorted jumper cables and 2 x daisy-chain cables with 5 x connectors. With a transformerless design the PSU-HSB-ALL eliminates the 50/60-cycle hum and noise. The Behringer PSU-HSB-ALL features a 2-pin Euro plug and is designed for use with 220V - 240V sockets.

The Dunlop ECB-003 UK is an 9V power supply designed for Dunlop effects pedals. With a negative centre and 9 volts of DC current on tap the ECB-003 UK features a UK three-prong plug type and is the correct power supply unit for some of Dunlops extensive pedal range.

The Boss PCS-20A Multi Cable is the ideal companion for FX pedals allowing players to use their pedal to provide power to 7 additional pedals. Its 1 metre of reach makes it ideal for large pedalboards ensuring you can cover all your pedals for the perfect performance.

The Mooer Wall 9V Pedal Power Supply is the source for all your music a power cable you can always count on. The durable design means this is perfect for a gig environment. Able to withstand any on-stage antics that can sometimes occur. Youll also be able to perform with confidence as your pedals will remain switched on and delivering sonic magic for the duration of your gig. This power supply securely attaches onto your pedal with enough length so you can put your pedals wherever is best for you. At an affordable price you can ensure your gig goes smoothly - gear you can trust. Please note: Image is of US Plug but product comes with UK plug.

The RockBoard RBO B Tray Universal PSU Mount is compatible with almost any multi-power supply unit. The RBO B THE TRAY can be mounted underneath any of the new RockBoard pedalboards (except the Duo 2.0). The pedalboards vertical support braces allow you to mount the tray without needing to drill any holes in the pedalboard. The tray can be easily fixed to the pedalboard using only 1 screw. Players can easily strap power supply units to the tray using screws or cable ties.

The Behringer CL9 Compressor/Limiter Pedal allows you to balance every aspect of your performance. Ensuring each note rings at a similar volume consistently guaranteeing that quiet notes cut through the mix while louder and harsher notes are dampened to ensure that they arent lost within the performance. This allows you to play with subtle nuance while also having the peace of mind that each aspect of your playing is captured perfectly.

The Behringer BEQ700 Bass Graphic EQ allows guitarists to shape their perfectly desired bass tones with 7-band equalisation. Each band offers up to 15 dB of boost or cut and covers a frequency range from under 50Hz to over 10kHz letting you sculpt your sound over a wide range. The BEQ700 has an integrated status LED to show when the effect is on and the status of the battery life. The bass pedal operates on a 9-volt battery or the PSU-SB DC power supply (sold separately).

Power to the pedals. The Mooer Wall 9V Pedal Power Supply offers you the means to fill your pedal with exactly what it needs - electricity. Coming with an EU plug it is perfect if you plan to take your gear to the continent or of course if you live there already. Whether you want to power a single pedal or daisy chain multiple pedals this power supply will happily deliver. With Mooers exceptional craftsmanship at its back it is perfect for the stage offering solid reliability and durability. You can count on it to deliver. *Please note: Picture is of UK version of product this product comes with EU plug*

The Behringer UT300 Ultra Tremolo Pedal offers up the vintage tremolo effects present in 50s and 60s amplifiers. Compact lightweight and easily transportable this handy stompbox fits excellently into your setup providing equally impressive tones. The tone can be sculpted with impeccable ease thanks to three dedicated controls including a Rate Wave and Depth allowing the creation of a multitude of unique sounds that infuse your performance with impeccable depth. Powered through a 9-volt battery you can easily check the status of your pedal with an on/off LED.

The Behringer OD300 lets you combine and balance overdrive and distortion to find your ultimate dirt tone. This is achieved thanks to clever design inside are two separate circuits- 1 for overdrive and another for distortion (identical circuitry to a famous orange distortion pedal and yellow overdrive). The pedal then lets you blend these signals together with the added ability to tweak gain level and adjust tone for even more sonic adaptability. The end result is the most customisable dirt tone on the market.

The Behringer EQ700 Graphic Equalizer Pedal offers complete tonal shaping across the full range of frequencies. Either boost or cut each band up to 15dB providing your tone with the utmost customisation. You can highlight every critical frequency drawing out certain aspects of your guitar elevating chordal playing with scintillating highs or giving your riffs additional depth thanks to its range from 100Hz to 6.4kHz. Drawing out every aspect you can create the ideal guitar tone.

The Behringer TO800 Vintage Tube Overdrive pedal is a faithful recreation of that classic green overdrive. The inclusion of the defining 4558 op-amp chip is a nice nod to the original design along with the familiar 3-knob layout which both looks sleek and is remarkably easy to use. With these controls you can adjust the level of the effect adjust the tone and set how much gain youd prefer. This allows you to sculpt your tone however you see fit from a light boost to thick resonant overdrive. Whatever crunchy tone youre after the TO800 will deliver.

The Behringer UC200 Chorus Pedal enhances every aspect of your guitars tone giving it additional richness thickening every aspect of the guitars sound with a chorus effect that can deliver stereo amazement. With individual controls for the Level Tone Rate and Depth you have an impressive amount of tonal shaping options. When the pedal is inactive you can be assured that your full signal integrity is upheld with maximum clarity and accuracy.

The Behringer VD400 Vintage Analogue Delay is the perfect effect for generating the authentic delay sounds reminiscent of studios in the 1960s. Utilising three intuitive controls the pedals sound can be fully customised for any style and genre with adjustable Intensity Echo and Repeat Rate - it can be widely adjusted. Ranging from elastic delay to vintage slap-back echo the 300ms of true delay works brilliantly with an incredible noise reduction circuit.

The Behringer UV300 Ultra Vibrato Pedal delivers vintage-inspired vibrato echoing the influence of the 60s and 70s. The vibrato pedal offers three separate settings to operate as well with unlatch bypass and latch which offer different opportunities for tonal creation. This tonal exploration doesnt stop there with dedicated Depth Rate Rise and Mode controls you can adjust every parameter of your sound to achieve your ideal setting. Utilising an active LED you can easily check the status of the pedal at any moment.

The Decksaver BOSS STOMP BOX Cover is a high-quality cover designed to accommodate your stompbox protecting it while on the move. The custom moulded protective cover is constructed from a highly-durable polycarbonate shell for optimal strength. The cover helps to protect your pedals from dust liquid accidental impact damage and more while on the move. The precision trimmed design of the Decksaver cover allows you to accommodate cables and more so your equipment is always ready to go. With its smoked clear finish the cover allows you to see your controller at all times. Please Note: Pictures are for reference only and the cover does not include the pedal.

The Decksaver Strymon Nightsky and Volante Cover is a high-quality cover designed to accommodate your electric guitar pedals protecting your equipment while on the move. The custom moulded protective cover is constructed from a highly-durable polycarbonate shell for optimal strength. The cover helps to protect your pedals from dust liquid accidental impact damage and more while on the move. The precision trimmed design of the Decksaver cover allows you to accommodate cables and more so your equipment is always ready to go. With its smoked clear finish the cover allows you to see your controller at all times. Please Note: Pictures are for reference only and the cover does not include the pedal.…

The Behringer TU300 Chromatic Tuner is a necessity for any modern performer. Keeping your instrument at the correct tuning is essential to any performer and this makes that job a whole lot easier. Featuring a seven-segment LED indicator you can select between seven different tuning modes and an eleven-point stream meter can ensure the utmost precision at any moment. Whether you are on stage or in the studio this is the perfect companion for you.

The Decksaver Eventide H9 & H9 MAX Cover is a high-quality cover designed to accommodate most two-button switch guitar pedals by Eventide protecting your equipment while on the move. The custom moulded protective cover is constructed from a highly-durable polycarbonate shell for optimal strength. The cover helps to protect your pedals from dust liquid accidental impact damage and more while on the move. The precision trimmed design of the Decksaver cover allows you to accommodate cables and more so your equipment is always ready to go. With its smoked clear finish the cover allows you to see your controller at all times. Please Note: Pictures are for reference only and the cover does not include …

The Decksaver Eventide 3 SWITCH Cover is a high-quality cover designed to accommodate most three-button switch guitar pedals by Eventide protecting your equipment while on the move. The custom moulded protective cover is constructed from a highly-durable polycarbonate shell for optimal strength. The cover helps to protect your pedals from dust liquid accidental impact damage and more while on the move. The precision trimmed design of the Decksaver cover allows you to accommodate cables and more so your equipment is always ready to go. With its smoked clear finish the cover allows you to see your controller at all times. Please Note: Pictures are for reference only and the cover does not include …