Chargers & Jump Starters

Victron Energy Skylla IP65 12-Volt 70 amp Battery Charger (3) features 3 isolated outputs (3 Bank) - All outputs can supply the full rated output current
LCD display for status monitoring and to easily adapt the charge algorithm to a particular battery and its conditions of use
The Storage mode feature provide less maintenance and aging when the battery is not in use, to increase battery life, every Victron Energy Skylla IP65 comes with a battery temperature sensor
In order to compensate for voltage loss due to cable resistance, a voltage sense facility is provided so that the battery always receives the correct charge voltage
Incorrect installation can be hazardous, Please consult a licensed …

Victron Energy Skylla-i (1+1) features 2 isolated outputs. The second output, limited to approximately 4A and with a slightly lower output voltage, is intended to top up a starter battery
A modern and powerful battery charger.
The right amount of charge for a lead-acid battery: variable absorption time
BatterySafe mode: preventing damage due to excessive gassing
Storage mode: less maintenance and aging when the battery is not in use

Victron Energy Quattro 24-Volt 3000VA 70 amp is a combined 230V inverter and battery charger, additionally it can be connected to two independent AC sources
In the event of grid failure, Victron Energy Quattro takes over the supply to the connected loads. This happens so fast that computers and other electronic equipment will continue to operate
With the unique Power Assist feature Victron Energy Quattro will prevent overload of a limited AC source, such as a generator or shore power connection
Up to 6 Victron Energy Quattros can operate in parallel to achieve virtually unlimited power, three phase or split phase operations are also possible
Incorrect installation can be hazardous, Please …

Victron Energy Quattro 12-Volt 3000VA is a combined 230V inverter and battery charger, additionally it can be connected to two independent AC sources
In the event of grid failure, Victron Energy Quattro takes over the supply to the connected loads. This happens so fast that computers and other electronic equipment will continue to operate
With the unique Power Assist feature Victron Energy Quattro will prevent overload of a limited AC source, such as a generator or shore power connection
Up to 6 Victron Energy Quattros can operate in parallel to achieve virtually unlimited power, three phase or split phase operations are also possible
Incorrect installation can be hazardous, Please consult …

Victron Energy Phoenix 12-Volt 50 amp Microprocessor Battery Charger with two full rated outputs and one 4 amp output
Victron Energy Phoenix Charger features a microprocessor controlled adaptive battery management system that can be preset to suit different types of batteries
The adaptive feature will automatically optimise the charge process relative to the way the battery is being used
Victron Energy Phoenix Charger comes with a battery temperature sensor, when connected charge voltage will automatically decrease with increasing battery temperature
Incorrect installation can be hazardous, Please consult a licensed professional and follow all applicable electrical codes during installation…

The VICTRON ENERGY Orion-TR Smart 24/12-20A 240W Isolated DC-DC Charger Blue is an advanced electronic charging device designed for efficiently converting and regulating DC power. This charger is specifically designed to convert 24V DC power to 12V DC power with a capacity of up to 20 amps and a maximum power output of 240 watts. Featuring smart charging technology, this charger is capable of automatically adjusting the charging current and voltage to ensure optimal charging performance for various types of batteries. It is equipped with intelligent battery protection functions such as overcharging, overheating, and short circuit protection to safeguard the connected battery from damage.The …

With M6 / 1/4 inch eyelets that fit perfectly on your motorsport and most car battery terminals, and 15A fuse that protects the cable and electronics that can be used up to -40°C - premium quality!
Encapsulated monitor with 3 LEDs shows the charge status of the battery from full to empty for 12.8V / 13.2V LiFePO4/LFP batteries - The LED corresponding to the charging status flashes every 5 seconds.
SAE quick connection for charging the battery when required - with weather-resistant cap for use while driving
Indicates the charging system status when the engine is running, with fourth LED that indicates if the system is charged with more than 14.6V, which can damage lithium batteries - hassle-free c…

Convert your older TecMate or British charger battery cable to SAE connector with weather protected sleeve and cap!
Length=6″/15cm.
-40°C/-40°F very low temperature use.
Cable max. rating: 5 Amp. 15A fuse.
KET 2 pole connector with locking clip converts to an industry standard 2-pin SAE connector.

Converts any Ducati-specific battery charging port below the seat (for newer model, it converts into a 2-pin SAE connector in accordance with industry standards).
Length: 12 inches/30 cm.
-40 °C/-40 °F suitable for use at very low temperatures. cable stays flexible at sub-freezing temperatures.
Max. cable values: 5 Amp. 15 A Fuse.
With seal cap for OptiMate heavy-duty SAE connector.High-Quality Cable, Developed by TecMate. -

Charge extension lead
Item Package Length: 21.2cm
Item Package Width: 13.3cm
Item Package Height: 3.6cm

Plug with twist off adapter, fits 12mm BIKE/DIN or cigar / AUTO sockets, power delivered through an industry standard 2-pole SAE connector!
Length=20″/50cm.
Note – before ordering, please check that your cigarette lighter is live when the ignition is OFF.
8A fuse (inside connector). Cable max. rating: 5 Amp.
Industry standard 2-pin SAE connector. includes in-line rubber seal for OptiMATE heavy duty SAE connector.

FLEXIBLE BATTERY CHARGER AND SAFETY DEVICE FOR THE WORKSHOP

The Victron Energy Multiplus is a powerful 12-Volt 3000VA 120 amp 230V true sine wave inverter and a sophisticated battery charger with adaptive charge technology, transfer switch 16 amp
With the unique Power Assist feature the MultiPlus will prevent overload of a limited AC source, such as a generator or shore power connection
In the event of a grid failure, or when shore or generator power is disconnected, the inverter is activated fast, within 20ms, and takes over the supply to the connected loads
Up to 6 MultiPlus units can operate in parallel to achieve virtually unlimited power, Three phase or split phase operations are also possible
Incorrect installation can be hazardous, Please …

VICTRON´s Energy MultiPlus C 12/1200/50-16 Inverter Charger brings toge ther, in a single compact housing, a powerful sine wave inverter, a sophisticated battery charger with adaptive technology and a high-speed AC transfer switch the Victron MultiPlus compact brings toge ther, in a single compact housing, a powerful sine wave inverter, a sophisticated battery charger with adaptive technology and a high-speed AC transfer switch.Victron Multiplus Inverter Chargers are compatible with Lithium-Ion batteries.Technical features.Two AC outputs the main output has a no-break function the MultiPlus takes over the supply to the connected loads in the event of a blackout or disconnection of the mains/generator t…

An Inverter/Charger with device networking built-in.The MultiPlus-II GX communicates with a solar charger, batteries, and other devices to control a grid-connected, off-grid, or remote power installation.Capable of parallel operation for increased power output, or battery charge-rates.The MultiPlus-II GX can also be configured for three-phase supply.A host of advanced features - such as uninterrupted power supply, setting load limits, and supplementing limited grid-power availability with battery power - can all be controlled straight from your phone or smart device.Remote monitoring is also possible.A MultiPlus-II with LCD and GX functionality The MultiPlus-II GX integrates a MultiPlus-II inverter/charger …

Victron Energy M6 eyelet connector with fuse is an accessory of the Blue Power IP65 Charger with DC connector
This connector features M6 eyelets for connection to the battery and an in-line, splash-proof fuse holder fitted with a 30 amp standard blade (ATO) fuse for protection against accidental shorts
This connector is useful if you have a hard-to-reach battery as you can leave the eyelets permanently connected to the battery and just plug the charger into the connector when required
It's also a good option if you need M6 eyelets for your battery connections rather than the M8 eyelets
The traffic light system shows your battery charge status simply and clearly

【Supper Starting Current & Ultra-long Standby time】
【Vibration Damping Technology&Excellent Stability】
【Intelligent & Multi-Protection & UL Listed】
【4 In 1 Multi-Function】
【Reliable Warranty and Life-time Service Support】

The Gysflash 100-12 HF is a stabilized inverter technology power supply with 5 functions
Charge batteries with a device with an advanced charging curve
Support 12V batteries (gel or liquid) of vehicles in the diagnostic phase
Ensure the health of the battery of a demonstration vehicle in showroom
Compensate for electrical requirements to save memories, when changing battery

This device will bring 4G LTE-M connectivity to all Victron Energy VE.Direct enabled devices without any monthly fees or subscriptions, for the first five years
The GlobalLink 520 comes with two communication ports, which allows connecting up to two VE.Direct devices. With two digital inputs that also act as pulse counters and a remote controllable relay, it's a perfect solution to monitor and control your installation
Monitor battery state of charge, power consumption, power harvest from PV, generator and grid or check temperature measurements. Follow up on alerts and perform diagnostics checks
RuuviTag support: These sensors connect via BLE and are easy to setup via VictronConnect. All …

A dual-size 12-volt male plug connector for standard and mini 12-volt auxiliary ports.
LED indicator that displays when the 12-volt auxiliary port is active.
Built-in 20A micro-blade fuse for increased safety and protection.
Rugged, watertight connector for maximum performance.
Compatible with G750UK, G1100UK, G3500UK, and G7200UK, as well as GENIUS1UK, GENIUS2UK, GENIUS2X2 GENIUS2X4, GENIUS5UK, and GENIUS10UK. Not compatible with NOCO Boost or Boost X UltraSafe Lithium Jump Starters.
For Use with G1100EU and G3500EU
Ergonomically Designed to Make Battery Connecting and Disconnecting Effortless
Built-In Fuse Protection to Protect Against Potentially Dangerous Short Circuits
Plug-N-Play …

Meet the GENIUSPRO50 - Similar to our G26000UK, but delivers 230% more power. With the greatest performance and functionality yet, it's a commercial-grade battery charger to let professionals push the limits at incredible charging speeds.
Do more with Genius - A multi-voltage charger - 6-volt (50A), 12-volt (50A), and 24-volt (25A) - for lead-acid automotive, marine, leisure, and deep-cycle batteries, including flooded, gel, AGM, EFB, SLA, VRLA start-stop and maintenance-free, plus lithium-ion (lifepo4) batteries.
Engineered for pros - Designed for professionals who need absolute performance and uncompromising functionality. Featuring ultra-flexible silicone cabling - down to -40ºC - with p…

Protect your GB70 jump starter with a lightweight, crush-resistant, anti-shock, and weather-resistant case.
Made from a rugged and durable EVA material with a soft melange velvet lining for a secure, scratch-free fit.
Secure enclosure with a durable, precision steel-rimmed zipper, a built-in reinforced handle, and custom over-molded pull tabs.
Portable carrying case design that's compact and lightweight and fits in most glove boxes or compartments.
Customized to fit the GB70 UltraSafe Lithium Jump Starter, plus included accessories.

The Einhell CE-BC 1 M battery charger is an intelligent universal battery charger with a microprocessor controller for a wide variety of battery types used in motorcycles and lawn mowers.
In the period before/after winter, the charger provides indispensable service for seasonal vehicles. The battery charger is suitable for use in the workshed and garage on the basis of IP65 protection (dust-tight and protected against jet-water spray)
Among other things this universal and versatile battery charger can be used to charge up 6 V and 12 V vehicle batteries, gel and AGM batteries, and zero and low maintenance lead-acid batteries.
The multi-stage charging cycle is controlled and permanently monitored …