Phanteks Enthoo Elite black (PH-ES916E_BK)

4mm sand-blasted aluminum exterior. Tool-less 4mm tempered glass window. Clean interior with aluminum covers – Hidden PSU & Cables. Ambient RGB Illumination Tri-chamber design – Hidden PSU, Isolated Storage/Cooling Chamber, Main Chamber. Full Size GPU Support. Front I/O with dual system support Convenient Installation in standing position. Integr... moreated RGB illumination mode and MSI Mystic Light and Asus Aura compatible. Tempered Glass Panel on hinges 35mm cable management space + additional cable compartment. Equipped with Phanteks’ Velcro cable ties. 2x Phanteks PWM Hubs Multifunctional cable cover. Swappable panels (performance/silent). Support Dual system (ITX)/ Dual PSU. Vertical GPU mount bracket.

Rarely has the sobriquet Elite seemed more fitting than in the instance of this modular full-tower case: The Phanteks Enthoo Elite!The Dutch case manufacturer has taken a giant leap forward in the Enthoo series and combined the design elements of Enthoo Primo with a huge variety of impressive features that leave this full-tower in a class all of it... mores own. The Phanteks Enthoo Elite represents a milestone in the development of PC cases everywhere and offers overclockers and enthusiasts the ultimate case!Phanteks Enthoo Elite: Full Tower with Three-Chamber DesignThe interior of the Phanteks Enthoo Elite is subdivided into three chambers: the main area, a lower area, and an area that encompasses the space behind and under the motherboard tray. The last of which offers space for cable management (35 mm), vertical installation of an ATX power supply on the floor, mounting options for HDD brackets and pump holders, in addition to SSD mounts. The lower chamber can also be reserved for the installation of a power supply - in this instance a small panel is removed on the reverse of the case. Particularly remarkable however is the floor of the chamber, which allows for the installation of a 420- or 480 mm radiator. Additionally the intermediate floor of the main chamber can be removed to allow access to the lower chamber. From this point it's only a few more steps to allow the installation of a mini ITX motherboard.Modular Full Tower with Big Functionality - The Enthoo EliteThe main chamber of the Enthoo Elite offers a lot of interesting features and is capable of containing motherboards up to E-ATX in size. Among the many special features of this full tower case there exists the option of vertically mounting the graphics card - and once again this only requires a few simple steps. The huge tempered glass window also affords you a view of the cooler (or the waterblock) of the graphics card. Depending on your preferred spacing, there are four PCI brackets available after modifying the case and a PCIe riser cable comes as standard with this full tower case. Around the motherboard are located a generous number of rubberised feedthroughs to enable clean cable management. If you look through the window at the area to the right of the motherboard, you will see it can be used as a space for installing SSDs, HDDs or reservoirs (accessory optional). Should none of these options be selected, this area can be stealthily concealed by using the four enclosed panels!Extreme Full Tower for High-End HardwareAs a "full tower" case, the Enthoo Elite can contain an impressive arsenal of potent gaming hardware. One benefit of its generously-proportioned frame is the ability to install multiple graphics cards without any hindrance, as long as the space next to the motherboard is not allocated for other components. In regards to the mini-ITX system that can be installed between chambers, the GPU utilised must be a dual-slot cooler or smaller. CPU coolers on the primary