Other Hand Tools

Wrecking Bar 16 x 460mm Non Sparking Al-Bron by EGA Master

24mm Lewis Auger Bit OAL1080mm Spiral Length 1010mm, 1410024 "Lewis" pattern, milled version relief precisely machined, screw threading centre point, main edge and cutting lips of premium quality. HEX shank from 8mm. For drilling deep holes in soft wood and European hard wood with power drill and joinery machine., 1410, 141002400

40mm Lewis Auger Bit OAL 300mm Spiral Length 220mm, 1410340 "Lewis" pattern, milled version relief precisely machined, screw threading centre point, main edge and cutting lips of premium quality. HEX shank from 8mm. For drilling deep holes in soft wood and European hard wood with power drill and joinery machine., 1410, 141034000

Strong-arm ratchet threading set complete with 1/2", 3/4" and 1" quick change dies. Manufactured to the highest quality with comfortable 2-part handle to give greater leverage. Complete with tough moulded carry case.

Model:Retention Ring 54mm Spline Diameter Spline Diameter:54 mm

A quick and easy way to cut clean metric sized holes in sheet metal up to 16 gauge. The special design allows even load during cutting and produces a burr free hole that needs no extra finishing. Heat treated cutting edges with black anti-corrosive surface finish to prevent rusting. All punches are sold singly without key, which should be ordered separately. Thread the punch onto the hexagonal screw and then pass the hexagonal screw through the hole. Position the die on top of the die nut and then screw the die nut onto the projecting hexagonal screw until it touches the metal sheet. Use a hexagonal key to turn the hexagonal screw. The screw will pull the punch through the metal and a hole

Hollow Punch Set From 3 To 30MM +Compass 330MM With Bi-Material Handle To Manufacture Gaskets, Seailing Rings In Different Materials Like Rubber, Plastic, Aluminium Sheets

PULLER LEG - set of 3

1.06/2-E - Quick release puller, 2 arm pattern 160 x 150mm

1.18/3 - Puller, 2 arm pattern 200 x 2000mm

Puller 120x120 mm

Puller 3-arm pattern 130x160 mm

Puller with sliding hammer

Drift Pin Barrel & Straight 1.1/4" 250 x 26mm Non Sparking Al-Bron by EGA Master

Expanding Head 35mm by EGA Master

Flaring Tool 1/4"-3/4" (Eccentric Cone) by EGA Master

Flaring Tool 6-16mm (Eccentric Cone) by EGA Master

Scraper 60 x 200 Non Sparking Al-Bron by EGA Master

Scraper 60 x 200 Wooden Handle Non Sparking Al-Bron by EGA Master

Front pockets with concealed zipped pockets underneath Front side cargo pockets with velcro flap closure Rear pockets with velcro closure Elasticated waist for comfort Knee pad pockets

Front pockets with concealed zipped pockets underneath Front side cargo pockets with velcro flap closure Rear pockets with velcro closure Elasticated waist for comfort Knee pad pockets

Front pockets with concealed zipped pockets underneath Front side cargo pockets with velcro flap closure Rear pockets with velcro closure Elasticated waist for comfort Knee pad pockets