Car Amplifiers

Class D 4-Channel Power Amplifier CEA-2006 compliant Hi-Res Audio compliant 75W x 4 RMS power output Frequency Response 20Hz Variable High & Low Pass Filter Speaker level input Wired remote included for B-channel

Rated continuous (rms) power @ 14.4 v @ 4 ? 75 w rms x 2, @ 2 ? 100 w rms x 2, bridged @ 4? 200 w rms x 1 Rated continuous (rms) power @ 12.5 v @ 4 ? 60 w rms x 2, @ 2 ? 90 w rms x 2, bridged @ 4? 180 w rms x 1 Min copper power / ground wire gauge 8 awg wire

Low Distortion Full On-Board Protection Proprietary High-Conductivity Terminals Remote Bass Control

Built-in internal 6-channel amplifier and High Resolution processing (96kHz/24Bit) Alpine Optim6 features automatic sound tuning through PC App or IOS App for the iPhone Intuitive Realtime Sound Set-Up with 5 Minute Self-Tuning Manual & Automatic Sound Tuning with PC App Control Automatic Sound Tuning with iPhone App

Hertz H8 DSP 8 Channel DSP Digital Sound Processor

Amplifier 300-watt x 1 powered amplifier. Ip66 rated water resistant design. Alpine's dynamic pulse power (dpp) technology delivers bursts of power during rigorous musical passages, effectively doubling the amp's power when needed. High quality, waterproof connector, for use in exposed areas such as side-by-sides, boats, open-top vehicles. Alpine's class d amplifier circuit with dynamic pulse power (dpp) Weather resistant (ip66 rating) Cta-2006-b specifications: 300w rms x 1 (2 ohm @ 14.4v = 1% thd+n). 600w dpp x 1 (2 ohm @ 14.4v, = 1% thd+n)

Rms power 4o: 50 watts x 4 2o: 75 watts x 4 Peak power: 600 watts Signal sensing turn-on

Compact Series Monoblock Class D Car / Marine Amplifier RMS Power Rating: 4 ohms: 200 watts x 1 chan. / 2 ohms: 300 watts x 1 channel Max power output: 600 watts x 1 channel Pulse Width Modulated MOSFET power supply LED power (green) and protect (red) indicators: Soft start turn-on

Four Channel Power Amplifier with class D digital technology for glass tone Aluminum housing for optimum heat dissipation Adjustable input sensitivity (0.2 power supply: 3 V-5 V Power supply with Mos FET Power transistors Box contents: Kenwood W/M1804, DC Cable, RCA cable (2x), thread screws 4x16 (4x), cable ties (2x)

Max Power 1600W Variable High & Low Pass Filter with Bass Boost Rich and Immersive High-Resolution Audio RMS POWER OUTPUT (4Ω): 50W x 4 + 300W / RMS POWER OUTPUT (2Ω): 75W x 4 + 500W RMS POWER OUTPUT Bridged: 150W x 2 (Bridged) + 300W

Class D Technology 4-Channel Amplifier 600-Watts Maximum Power Bass Boost Capabilities Signal Sensing Turn-On 8-gauge Power and Ground Leads Recommended

JX Series Monoblock Amplifier 500 rms @ 4ohms 750 rms @ 3ohms and 1000 rms @ 2ohms Unregulated PWM switching type power supply Variable Bass Boost (0 to +12 dB bass boost centered at 45 Hz) Soft start turn-on prevent clicking and popping when system turns on Dimensions: 11"L x 7-3/4"W x 2"H

Frequency Response: 7 Hz - 500 Hz (+0, -1dB) Damping Factor @ 4 Ω: >1000 / 50 Hz Damping Factor @ 2 Ω: >500 / 50 Hz Min.Copper Power / Ground Wire Gauge: 4 AWG wire S/N Ratio, referred to 1 W: >50 dB (A-weighted, 20 Hz - 20 kHz noise bandwidth)

High-Efficiency, Low Distortion Class D Design Noise-Rejecting Differential Inputs Active LPF, variable 32 – 320Hz Variable Line-Level and Speaker-Level Inputs (0.2 to 20V input range)

Class D amp technology Bridge selector switch controlled by microcomputer Variable low pass and High pass filter Waterproof detachable connector Continuous Power Output Normal Mode: 300W RMS (2Ω)

Class D 5 Channel Amplifier 2000 Watts MAX Power Variable HPF/LPF Gold RCA Terminal Hi-Res Capable Bass Boost Remote Included