FiiO FT3 32 Ohm

Large Dynamic High-Res Over-Ear Headphones 60mm, with large dynamic driver. LCP aluminum metal plated+aluminum metal diaphragm 32Ω impedance With a 1.5m long, 23AWG thick in diameter cable made up of 392 silver-plated monocrystalline copper wires. Asymmetric internal and external magnetic circuit system. 4 different audio plugs included, as well... moreas leather case and 2 sets of earpads Sensitivity: 110dB | Frequency Response Range: 7Hz-40kHz

Finally a FiiO FT3 headphone variant available that is ideal for mobile use! High-end hi-fi, easily accessible 32-Ω design A sense of relaxation wrapped in dense mids and bass The 32-Ω version of the FT3 focuses on delivering lush but very textured mids and bass. The bass is very present and robust, yet very controlled and detailed. The... moremids are also lush and relaxed, making the FT3 very pleasant to listen to. 60 mm large dynamic driver Sound is created by the vibration of material - so the choice of driver is very important to sound quality. The FT3 features a large 60 mm dynamic driver, which is unusual in its class. Compared to a smaller driver, the FT3 can expel more air and convert the energy into sound more efficiently - resulting in a more natural yet robust sound with a wide soundstage. The FT3's large dynamic driver has other advantages as well. For example, the diaphragm's size enables it to carry a higher output power, resulting in less distortion from large dynamic signals. In addition, the larger driver is more easily able to produce lower frequencies to achieve deeper bass. Sophisticated design - Beryllium-coated gasket + DLC diaphragm The diaphragm is one of the most important components of a dynamic driver. And not every diaphragm material can meet the FT3's requirements due to the large driver size. After countless tests at FiiO, an LCP/aluminium-coated driver/seal was chosen for the more portable 32-ohm version. The seal of the FT3 driver is coated with aluminium. This not only results in a lighter gasket (and thus a lighter driver), but also a stiffer gasket that is better able to handle the movements of the large dynamic driver, resulting in less distortion. The FT3's diaphragm is made of LCP, which is very robust and lightweight compared to other diaphragm materials. This means that the FT3 driver is less prone to breakage and therefore non-linear distortion, while at the same time having an extremely extended frequency response and improved soundstage. Pure sound - 32Ω high impedance The voice coil is made of ultra-fine copper-clad Japanese aluminium with a diameter of only 0.035mm. This finer voice coil allows the driver to follow signals better and faster, has anti-interference capabilities and enables thunderous dynamics over a wide frequency response range. Hear the artist's intent - Asymmetrical internal and external magnetic circuit system The FT3 uses powerful N52 neodymium magnets to maximise sound quality at an impedance of 32Ω. These magnets are arranged in an optimised asymmetrical internal and external magnetic circuit system. When the voice coil begins to move during sound reproduction, the optimised magnetic circuit compensates for this voice coil and diaphragm movement, especially during large dynamic changes - allowing more effective use of magnetic energy and better control over the voice coil. Quality cable - monocrystalline copper wire The FiiO FT3 32Ω comes standard with a